Instruction Guide for SleepPhones® Classic
How to Wear your SleepPhones®
3. Once the headband is on, you’ll want to adjust the
speakers so that they are positioned directly over your
ears. This will ensure great sound quality. Please note
that the speakers move inside of the headband,
independently of the headband.
2. Place the headband on your head. Note that the
SleepPhones® logo tag goes at the back of your
head. The cord comes out the hook & loop opening
at the back of the headband.
1. Holding the SleepPhones® in your hands, you’ll
notice the flat speakers - one on each side - inside of
the headband.
Removing the Speakers
1. There is a hook & loop opening at
the back of the headband. Open to
reveal the speaker components
inside the headband.
2. Pull very gently on the speakers,
one at a time, to remove them from
the headband.
3. Once the speakers are
removed, you can machine-wash
the headband.
!
1
2
3
1
2
3
Check out the instructional video!
Reinserting the Speakers
1. The right speaker will have red
stitching. The left speaker will have
green stitching. The softer gray
(fleece) side should be facing in
towards the ear and the coarse (felt)
side should face away from the ear.
2. Insert the speakers, one at a
time, about four inches from the
hook & loop opening on both sides
of the headband.
3. Then insert the junction pad
into the headband and close the
hook & loop opening.
1
2
3
Speakers
/
