Alpine KTX-RV48-S Installation guide

Type
Installation guide
Perfect Fit 2009-2012 Toyota RAV4 (Without JBL System)
Installation Manual
KTX-RV48-S
Introduction
This KTX-RV48-S Perfect Fit installation kit is for Select 2009-2012 Toyota RAV4 vehicles. In-
cluded are all the parts needed to install your Alpine INE-Z928HD Audio Video Navigation system
in Select 2009-2012 Toyota RAV4 vehicles. KTX-RV48-S Perfect Fit installation kit also includes
an interface module that allows steering wheel remote control of the Alpine system. Refer to the
individual instruction sections of this manual to remove your vehicle’s factory radio and assemble
the kit.
Caution! Disconnect your vehicle’s negative battery terminal before the installation to
help prevent electrical damage. We recommend the use of a digital multimeter to check
vehicle wiring. Do not use a test light! A test light or grounded wire probe can cause
damage to the vehicle’s computer and/or diagnostic systems. Avoid all factory airbag
wiring. Airbags can accidentally deploy causing serious injury or even death.
Notes:
oØ2DDØXNTQØUDGHBKDlRØHMRSQTBSHNMRØENQØ@MXØRODBH@KØSNNKRØXNTQØHMRS@KK@SHNMØLHFGSØQDPTHQD
oØ1D@CØ@KKØHMRSQTBSHNMRØ@BBNLO@MXHMFØXNTQØB@QØRSDQDNØENQØOQNODQØVHQHMFØ@MCØLNTMSHMFØ
instructions.
Left Bracket x 1
Right Bracket x 1
RAV4 Trim Panel x 1 Steering Wheel Interface
Module x 1
Power Harness x 1
1
Factory Stereo Removal
Ø4RDØ@Ø/@MDKØ1DLNU@KØ3NNKØSNØQDLNUDØSGDØO@MDKRØ
to the left and right of the radio.
2
Ø$WSQ@BSØØLLØANKSRØEQNLØ@QNTMCØSGDØRSDQDNØ
CHRBNMMDBSØ@MCØQDLNUDØ
Ø4MBKHOØSNOØUDMSRØEQNLØQ@CHNØ
Mounting The Radio
1. Attach left and right brackets to the Alpine head
unit using the supplied ISO screws (that come with
the head unit).
Ø4MOKTFØG@QMDRRDRØEQNLØQ@CHN
2SDDQHMFØ6GDDKØ"NMSQNKR
Steering Wheel Control Operation
(when vehicle is equipped)
Ø2DDJ3Q@BJØ4O
2. Seek/Track Down
3. Volume Down
4. Source
Ø5NKTLDØ4O
MODE
1
23
4
5
,NTMSHMFØ3GDØ2SDQDNØ"NMSHMTDC
3. Install head unit using the (4) 10mm bolts that
were removed earlier. Snap trim panel into vents
and over the radio.
3
4. Re-install the panels to the right and left of
the radio.
2. Plug in the supplied radio harnesses and steering
VGDDKØBNMSQNKRØ1TMØ!KTDSNNSGØLHBØØ&/2Ø@MSDMM@Ø
and install foot brake and parking brake wires.
Liability Disclaimer
#TDØSNØBG@MFDRØHMØCDRHFMØ@MCØL@MTE@BSTQHMFØSG@SØL@XØNBBTQØVHSGØXNTQØRODBHÚBØUDGHBKDØHSØ
is important that you do not rely solely on vehicle information contained in this installation
L@MT@KØRTBGØ@RØC@RGØCHR@RRDLAKXØVHQDØG@QMDRRØ@MCØBNCDRØ2TBGØHMENQL@SHNMØRGNTKCØADØ
BNMÚQLDCØVHSGØSGDØUDGHBKDØL@MTE@BSTQDQØ KOHMDØ$KDBSQNMHBRØ(MBØ@MCØHSRØ@EÚKH@SDCØBNLO@MHDRØ
is not responsible for damage that may occur to you or your automobile during the installation
of the Perfect Fit Kit.
(EØXNTØG@UDØ@MXØETQSGDQØPTDRSHNMRØEDDKØEQDDØSNØBNMS@BSØ KOHMDØ3DBGØ2TOONQSØ@SØ- 5'$+/
ALPINE ELECTRONICS OF AMERICA, INC., Ø&Q@LDQBXØ/K@BDØ3NQQ@MBDØ" ØØ42
Do not send products to this address.
"@KKØSGDØSNKKØEQDDØMTLADQØNQØUHRHSØSGDØVDARHSDØSNØKNB@SDØ@ØRDQUHBDØBDMSDQØ
Wiring Harness Diagram
4
INE-Z928HD
Audio
Video
Navigation
System
To Foot Brake (+) at
switch above pedal
To Parking Brake (-)
at the parking brake
in drivers kick panel
To Toyota RAV4
Vehicle Harness
10A
To Steering Remote
Input (Pigtail)
To Factory
OEM Aux Port
3NØ'D@CØ4MHSØ
/NVDQØ"NMMDBSNQ
To Steering Wheel
1DLNSDØ"NMSQNKØ
Module
Yellow/Blue
Yellow/Black
To Reverse Trigger
Ø4RDØNMKXØVHSGØ@Ø
back up camera (+)
side of the reverse
light
To aftermarket
@LOKHÚDQØQDLNSDØ
turn on
Blue/White
Orange/White
2010-up Steering
Wheel connector
(20-pin)
Or
2012-up Steering
Wheel connector
(28-pin)
-.-
--
--
PERFECT
'oQiu[J
~N
s
PERFECT
FIT™
INSTALLATION KIT
KIT
D'
INSTALLATION
PERFECT
FIT™
ALPINE
ELECTRONICS
OF
AMERICA,
INC.
www
.alpine.com
DRIVING MOBILE MEDIA SOLUTIONS
KTX-PRSS-5
2010-UP
TOYOTA PRIUS
INSTALLATION
KIT
(EXCLUDES PRIUS C
& V)
KTX-PRSS-5
2010-UP
TOYOTA PRIUS
INSTALLATION KIT
(EXCLUDES
PRIUS
C
&
V)
~
#/ff/ILPINE
®
Mobile
Media
Solutions
9
PERFECT SHAPE
AND
COLOR
MATCH
TO OEM DASH FOR FACTORY FIT
##MLPINE
®
INCLUDES ALPINE-TO-VEHICLE HARNESS FOR
PLUG-AND-PLAY INSTALLATION
INCLUDES RETAINING CLIPS
Mobile
Media
Solutions
INSTRUCTION
MANUAL
WITH STEP-BY-STEP INSTALLATION OF
ALL
COMPONENTS
CORRESPONDANCE PARFAITE
AVEC
LA
FORME ET COULEUR
DU
TABLEAU DE BORD
DE
L'EQUIPEMENTIER POUR
UN
ASPECT
SORTIE D'USINE
COMPREND UN HARNAIS POUR
CONNECTER
L'UNITE ALPINE
AU
VEHICULE POUR
UNE
INSTALLATION
PR~TE
A
L'EMPLOI
COMPREND LES CLIPS
DE
MAINTIEN
MANUEL
D'INSTRUCTIONS DETAILLANT L'INSTALLATION PAS
A
PAS
DE
TOUS LES COMPOSANTS
Alpine, Alpine Mobile
Media
Solutions,
Driving
Mobile
Media
Sol~.:~tions
are registered trademarks
of
Alpine Electronics, Inc.
Alpine, Alpine Mobile Media
Solutions,
Driving
Mobile
Media
Solutions
sont
des
marques deposees
d'Aipine Electronics,
Inc.
MADE
IN CHINA
FABRIQUE
EN
CHINE
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

Alpine KTX-RV48-S Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI