Perfect Fit For 2007-2012 Nissan Altima Installation Manual
KTX-ALT48
Power Harness x 1
Introduction
This KTX-ALT48 Perfect Fit installation kit is for Select 2007-2012 Nissan Altima vehicles. In-
cluded are all the parts needed to install your Alpine INE-Z928HD Audio Video Navigation system
in Select 2007-2012 Nissan Altima vehicles. KTX-ALT48 Perfect Fit installation kit also includes
an interface module that allows steering wheel remote control of the Alpine system. Refer to the
individual instruction sections of this manual to remove your vehicle’s factory radio and assemble
the kit.
Caution! Disconnect your vehicle’s negative battery terminal before the installation to
help prevent electrical damage. We recommend the use of a digital multimeter to check
vehicle wiring. Do not use a test light! A test light or grounded wire probe can cause
damage to the vehicle’s computer and/or diagnostic systems. Avoid all factory airbag
wiring. Airbags can accidentally deploy causing serious injury or even death.
Notes:
oØ2DDØXNTQØUDGHBKDlRØHMRSQTBSHNMRØENQØ@MXØRODBH@KØSNNKRØXNTQØHMRS@KK@SHNMØLHFGSØQDPTHQD
oØ1D@CØ@KKØHMRSQTBSHNMRØ@BBNLO@MXHMFØXNTQØB@QØRSDQDNØENQØOQNODQØVHQHMFØ@MCØLNTMSHMFØ
instructions.
Nissan Trim Panel x 1
(Panel 7395)
Radio Replacement
Interface Module x 1
1
Left Bracket x 1
(Panel 7397)
Right Bracket x 1
(Panel 7396)
Factory Stereo Removal
2
1. Use a Panel Removal tool to remove the vent
panel above the stereo.
1. Attach side panels to the INE-Z928HD using
screws that come with head unit. Remove
climate controls from factory panel and attach
to side panels as well.
2. Use a PRT to remove the panel below the radio
3. Remove 4 Phillips screws securing the radio
to the dash. Save these screws. They will be
used to install the new kit panel.
Mounting The Stereo
Steering Wheel Controls
Mounting The Stereo Continued
3
3. Plug in the supplied radio harnesses and
steering wheel controls. Run Bluetooth mic &
&/2Ø@MSDMM@Ø@MCØHMRS@KKØENNSØAQ@JDØØO@QJHMFØ
brake wires.
4. Mount the head unit and Perfect FIT trim panel.
Reinstall factory panels.
SOURCE
Steering Wheel Control Operation
(when vehicle is equipped)
1. Source
2. Seek/Track Up
3. Seek/Track Down
4. Volume Down
5. Volume Up
6. Answer Call / Voice Dial
7. Hang Up Call
2. The kit is designed to work with the digital or
analog HVAC controls. Attach the appropriate panel
to the front depending on the type of vehicle.
15A
Wiring Harness Diagram
Liability Disclaimer
#TDØSNØBG@MFDRØHMØCDRHFMØ@MCØL@MTE@BSTQHMFØSG@SØL@XØNBBTQØVHSGØXNTQØRODBHÚBØUDGHBKDØHSØ
is important that you do not rely solely on vehicle information contained in this installation
L@MT@KØRTBGØ@RØC@RGØCHR@RRDLAKXØVHQDØG@QMDRRØ@MCØBNCDRØ2TBGØHMENQL@SHNMØRGNTKCØADØ
BNMÚQLDCØVHSGØSGDØUDGHBKDØL@MTE@BSTQDQØ KOHMDØ$KDBSQNMHBRØ(MBØ@MCØHSRØ@EÚKH@SDCØBNLO@MHDRØ
is not responsible for damage that may occur to you or your automobile during the installation
of the Perfect Fit Kit.
(EØXNTØG@UDØ@MXØETQSGDQØPTDRSHNMRØEDDKØEQDDØSNØBNMS@BSØ KOHMDØ3DBGØ2TOONQSØ@SØ- 5'$+/
INE-Z928HD
Audio
Video
Navigation
System
To Head Unit
Power Connector
Yellow/Black
ALPINE ELECTRONICS OF AMERICA, INC., Ø&Q@LDQBXØ/K@BDØ3NQQ@MBDØ" ØØ42
Do not send products to this address.
Call the toll free number or visit the website to locate a service center.
10A
To Foot Brake (+) at
switch above pedal
4
To Parking Brake (-)
at switch
Yellow/Blue
1A
1. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not
QDPTHQDØOQNFQ@LLHMFØ
Ø3GDØ+$#ØVHKKØÛ@RGØVGDMDUDQØ@ØTRDQØOQNFQ@LL@AKDØ26"ØATSSNMØHRØOQDRRDC
To Steering Wheel
Connector on Head
Unit
To Reverse Trigger (+).
Use only with a back up
camera (+) side of the
reverse light
Orange/White
To Nissan Vehicle
Harness
Optional remote turn-on wire.
Blue/White
To Chassis
Ground (-).
Black
ffff//ILPINE
®
Mobile
Media
Solutions
~~
PERFECT
FIT™
INSTALLATION KIT
~ERFECf
ao~)J~N
a
•
KIT D' INSTALLATION PERFECT
FIT™
• •
KTX-ALT48
2007-2012
NISSAN
ALTIMA
INSTALLATION KIT
ALPINE
ELECTRONICS
OF
AMERICA,
INC.
www
.alpine.com
DRIVING MOBILE MEDIA SOLUTIONS
KTX-ALT48
2007-2012
NISSAN
ALTIMA
INSTALLATION KIT
"""""'
//ffMLPINE®
Mobile
Media
Solutions
• PERFECT SHAPE AND COLOR MATCH TO OEM DASH FOR FACTORY FIT
• INCLUDES ALPINE-TO-VEHICLE HARNESS FOR PLUG-AND-PLAY INSTALLATION
#ffbiLPINE®
• INCLUDES RETAINING CLIPS
Mobile
Media Solutions
• INSTRUCTION MANUAL WITH STEP-BY-STEP INSTALLATION OF
ALL
COMPONENTS
• CORRESPONDANCE PARFAITE AVEC
LA
FORME ET COULEUR DU TABLEAU DE BORD DE L'EQUIPEMENTIER POUR UN
ASPECT SORTIE D'USINE
• COMPREND
UN
HARNAIS POUR CONNECTER L'UNITE ALPINE AU VEHICULE POUR UNE INSTALLATION
PR~TE
A L'EMPLOI
• COMPREND LES CLIPS DE MAINTIEN
• MANUEL D'INSTRUCTIONS DETAILLANT L'INSTALLATION PAS
A PAS DE TOUS LES COMPOSANTS
Alpine,
Alpine
Mobile
Media
Solutions, Driving
Mobile
Media Solutions
are registered trademarks
of
Alpine Electronics,
Inc.
Alpine, Alpine
Mobile
Media
Solutions, Driving
Mobile
Media
Solutions
sont
des
marques deposees d'Aipine
Electronics, Inc.
MADE
IN CHINA
FABRIQUE
EN CHINE
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Alpine KTX-GM8W-O Installation guide
-
-
-
-
-
-
-
-
-
Other documents
-
Scosche NN1646B Datasheet
-
SICK KTS/KTX Prime - 5-PIN (IO-Link) Operating instructions
-
-
-
-
-
-
Directed Xpresskit DBALL2 Installation guide
-
-
ACV 381210-16-1 Installation guide