Dacor RNIVSR2 User guide

Type
User guide

This manual is also suitable for

PLANNING
GUIDE
All specications subject to change without notice. www.dacor.com Ph. 800.793.0093
Integrated Hood Liner
Doc #: PGH-IHL.01 Revised 14 Sept 2018 Page 1 of 1
All tolerances: ±¹/₁₆” (±1.6 mm) unless otherwise stated.
IHL
Height of IHL Hood Liner/IVS
Ventilation System When Assembled
Custom hood
Hood liner mounting
screw (quantity varies
with model; see table,
top left
Dacor IVS-series
integrated ventilation
system
Cap nuts/lock washers
to mount IVS unit
(provided in IHL kit)
21"
(53.3 cm)
13 7/16"
(34.1 cm)
4"
(10.2 cm)
A
Mounting hole
for IVS
IHL mounting hole,
number and locations
vary with model
C
L
10"
(25.4 cm)
IHL Hood-Liner Dimensions (see below)
Model (A) Width
Qty. of Mounting Holes/
Mounting Screws Required*
IHL30 27” (68.6 cm) 4
IHL36 33” (83.8 cm) 4
IHL42 39” (99.1 cm) 6
IHL48 45” (114.3 cm) 6
IHL54 51” (129.5 cm) 6
* #8 mounting screws (not included) are required. Length and type
depend on the specific application (mounting material).
Ventilation System Compatibility
IHL Model IVS Model
IHL30 IVS1
IHL36 IVS1
IHL42 IVS2
IHL48 IVS2
IHL54 IVS2
About the IHL-Series Integrated Hood Liner
Dacors integrated hood liner makes up the space between the
IVS and a custom-built range hood. The IHL is constructed with
non-combustible stainless steel. Together, IHL and IVS appliances
can be built into a custom hood structure to provide the required
ventilation needed to safely and efficiently remove cooking odors
and gases from the house.
Dacor IHL series
hood liner
WARNING
Observe all local ordinances during planning and installation. Contact
your local building department for details.
DO NOT install an additional inline or external blower to increase the
length of the duct run. Even small differences in blower airflow rates
can greatly reduce the air draw of the hood.
  • Page 1 1

Dacor RNIVSR2 User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI