Danfoss 087N7773 is a room thermostat that helps you save energy and money on your heating bill. It is easy to install and use, and it can be programmed to fit your lifestyle.
With the Danfoss 087N7773, you can:
- Set the temperature you want your home to be, and the thermostat will automatically turn on or off your heating system to maintain that temperature.
- Program the thermostat to different temperatures for different times of day or days of the week. For example, you could set the thermostat to a lower temperature when you're at work or asleep.
- See the current temperature and target temperature on the easy-to-read display.
Danfoss 087N7773 is a room thermostat that helps you save energy and money on your heating bill. It is easy to install and use, and it can be programmed to fit your lifestyle.
With the Danfoss 087N7773, you can:
- Set the temperature you want your home to be, and the thermostat will automatically turn on or off your heating system to maintain that temperature.
- Program the thermostat to different temperatures for different times of day or days of the week. For example, you could set the thermostat to a lower temperature when you're at work or asleep.
- See the current temperature and target temperature on the easy-to-read display.
About the heating in your home....
What is a Room Thermostat?
How does it work?
Why do I have one fitted in my home?
INTRODUCTION
Fitting room thermostats to control room temperatures can
be a very productive exercise. Room thermostats control the
temperature at which your heating system operates, and in
doing so helps save energy by cutting down on wasteful
overheating.
Fitting room thermostats also cuts down on heating costs
because by turning down the setting by just 1°C can cut the
heating fuel bill by up to 10%. Reducing wasteful overheating
also helps the environment by reducing harmful emissions.
HOW A ROOM THERMOSTAT WORKS
The thermostat controls the heating in your home by keeping
it at the temperature you have set. Room thermostats switch
off the heat when the temperature reaches set point, and
switch it on when it falls below. The heating will not come
on if the room temperature is above the room thermostat
set temperature. Remember that turning the thermostat up
will not heat the room any faster. The higher the thermostat
setting the more gas you will use.
SETTING THE TEMPERATURE
Press either the Λ or V buttons, the product backlight will
come on.
Press either the Λ or V button again within 6 seconds,
the display will flash the current set temperature. While
the display is flashing press the Λ arrow to increase the
set temperature to the required setting or the V arrow to
decrease the set temperature. If no buttons are pressed
the display will return to the actual temperature after 4
seconds and the backlight will go out after 6 seconds.
SYMBOLS
Flame: shows when the thermostat is
calling for heat.
Standby: shows when unit is manual
set to standby
Battery flashes when battery is low
(battery units only)
Antenna indictes a paired link is active between
the thermostat and receiver
RX1-S RECEIVER
If the RET2000B-RF thermostat and receiver have been
supplied together in a combined pack, the units have been
paired in the factory. If the units become unpaired please
follow these instrucitons, Press and hold both the PROG and
CH buttons. The PROG LED will light for 1 second when it has
paired with the RET2000B-RF. Release buttons. An ariel icon on
the themostat confirms the units are now paired and ready.
INSTALLER DETAILS:
RET2000B-RF + RX1-S Thermostat
Danfoss Heating
Danfoss Heating
Danfoss Heating
-
1
Danfoss 087N7773 is a room thermostat that helps you save energy and money on your heating bill. It is easy to install and use, and it can be programmed to fit your lifestyle.
With the Danfoss 087N7773, you can:
- Set the temperature you want your home to be, and the thermostat will automatically turn on or off your heating system to maintain that temperature.
- Program the thermostat to different temperatures for different times of day or days of the week. For example, you could set the thermostat to a lower temperature when you're at work or asleep.
- See the current temperature and target temperature on the easy-to-read display.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Danfoss RET2000 User guide
-
-
Danfoss ErP Classifications Datasheet
-
-
-
-
-
-
-