Global Direct 21236 Installation guide

STYLE# 21236

Careful unpack all lamp parts from the carton.

1.Carefullyremoveallpartsfromthecarton.

2.BesurethepowertotheinstallationpointisOFF.

3.FastentheCrossbartotheoutletbox.Locatethe

Nippleandthreadintothecenterofthe Crossbar.

4.LocatetheFixtureChain、CeilingCanopy、

CanopyChainLoop、andCanopyLockring.

Pass

theFixtureSupplyWireandGroundWires

throughinthefollowingorder:1)Alternate Fixture

LoopsintheFixtureChain;2)CanopyLockring;

3)CanopyChainLoop;4)CeilingCanopy.

Finally,proceedtopassthewiresthroughthe

NippleattachedtotheCrossbar,

5.ThreadCenterStemintotheHexCoupling

underside

oftheSocketCluster,Handtightenuntilsnug.

6.Locatedthefollowingcomponentsovertheendof

theCenterSteminturnDiffuser,RubberWasher,

FlatWasher.ThreadtheHexnutontotheendofthe

CenterStemandtightenuntilsnugtosecurethe

aboveparts.

7.ThreadedFinialontotheendofthe CenterStem

andhandtightenuntilsnug.

8.PuttheMarbleintotheShade.

9.LifttheShadeupwardandattachedtotheend

ofSupportArms .Locatetheend ofSupportArm

ontotheHooksinsideoftheMarbleShade.

10.Installcorrectbulbs(notincluded)referringto

fixturemarkingsand/orlabelsformaximumwattage.

Your installation is completed now. Restore electricity.

Retain this sheet for future reference !

ASSEMBLY INSTRUCTIONS