2. Rugged Ridge
  3. 11540.25

Rugged Ridge 11540.25 Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge XHD Double X Striker. This document details the steps for mounting the striker, highlighting important safety limits and proper usage, such as not using it for towing. I'm ready to answer any questions you have regarding this product and its installation process.
  • What is the maximum working load for the D-Ring mounts?
    Can the Striker Bar be used for towing?
    What should be done before installing the Double X Striker if there is an existing installation?
Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 1/1
11540.25
Rugged Ridge XHD Double X Striker
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Contents:
• Double X Striker (1)
4. Install front 8 bolts and washers (provided with center
section). Do not tighten bolts.
5. Once all 16 bolts have been started, tighten the front 8
bolts, followed by the top 8 bolts. Installation is now com-
plete.
To avoid serious injury: never exceed 6.5 ton
working load on D-Ring mounts. Use only to
assist in vehicle self-recovery; never use D-Ring
mounts as towing point. Inspect before use.
Replace if damaged or distorted. Striker Bar is
not to be used for towing or vehicle recovery.
1. If Double X Striker is being added to an existing instal-
lation; remove D-Rings and/or any top or front mounted
accesoires from center section. Center section should be
sitting on frame rails but not attached.
2. Place Double X Striker over center section and secure
with 8 top bolts and washers (provided with center sec-
tion). Do not tighten bolts.
WARNING
!
/