Rugged Ridge 11025.14 Installation guide

Type
Installation guide

This manual is also suitable for

Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Quick Release Mirror
Page 1/3
Part #11025.12
11025.13
11025.14
11025.18
11025.20
11025.22
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
1
2
3
4
5
6
1. Mounting Bracket
2. Thumb Screw
3. Bushing
4. M8 Bolt
5. Arm
6. Mirror
Components
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Quick Release Mirror
Page 2/3
2. Using supplied hardware, install Mounting
Bracket with welded nut facing down.
1. For JK (07-17): Using T40, Torx Wrench, remove
two upper windshield bracket bolts.
For TJ (96-06): Using T40 Torx Wrench, remove two
ush mount torx head bolts just in front of door
hinge.
3. Attach Arm to Bushing. Using Thumb Screw,
loosely install Bushing and Arm into Mounting
Bracket.
JK TJ
Copyright © 2016 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 100 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Quick Release Mirror
Page 3/3
5. When doors are reinstalled remove Arm from
bracket. Place Bushings back into Mounting
Bracket and tighten Thumb Screw.
4. Attach Mirror to at side of MArm using Mirror’s
hardware. Tighten screws on the back of the Mirror.
Mirror should be tighten but able to be adjusted if
needed.
For TJs (97-06), it is recommended to use
quick release mirrors without doors on
vehicle.
WARNING
!
  • Page 1 1
  • Page 2 2
  • Page 3 3

Rugged Ridge 11025.14 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI