Peerless PANA-85WM Installation guide

PANA-85WM
Peerless
Brand
Peerless
Model
PANA-85WM
Category
Wall & ceiling mounts accessories
Type
Installation guide
1 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
Model: PANA-85WM
Installation and Assembly:
Wall Mount for Panasonic TH-85PF12U and TH-85VX200U
Landscape
Portrait
Maximum Load Capacity:
270 lb (122 kg)
2 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
Table of Contents
Parts List.................................................................................................................................................................................3
Installation to Triple Wood Stud Wall ......................................................................................................................................4
Installation to Solid Concrete or Cinder Block ........................................................................................................................5
Installing Tilt Brackets .............................................................................................................................................................7
Mounting and Removing Flat Panel Screen ...........................................................................................................................8
IMPORTANT! Read instruction sheet before you start installation and assembly.
• DonotbegintoinstallyourPeerlessproductuntilyouhavereadandunderstoodtheinstructionsandwarnings
containedinthisInstallationSheet.Ifyouhaveanyquestionsregardinganyoftheinstructionsorwarnings,forUS
customerspleasecallPeerlesscustomercareat1-800-865-2112,forallinternationalcustomers,pleasecontact
yourlocaldistributor.
• Thisproductshouldonlybeinstalledbysomeoneofgoodmechanicalaptitude,hasexperiencewithbasicbuilding
construction,andfullyunderstandstheseinstructions.
• Makesurethatthesupportingsurfacewillsafelysupportthecombinedloadoftheequipmentandallattached
hardwareandcomponents.
• NeverexceedtheMaximumLoadCapacity.Seepageone.
• Ifmountingtowoodwallstuds,makesurethatmountingscrewsareanchoredintothecenterofthestuds.Useof
an"edgetoedge"studnderishighlyrecommended.
• Alwaysuseanassistantormechanicalliftingequipmenttosafelyliftandpositionequipment.
• Tightenscrewsrmly,butdonotovertighten.Overtighteningcandamagetheitems,greatlyreducingtheirholding
power.
• Thisproductisintendedforindooruseonly.Useofthisproductoutdoorscouldleadtoproductfailureandpersonal
injury.
• Thisproductwasdesignedtobeinstalledonthefollowingwallconstructiononly;
WALL CONSTRUCTION HARDWARE REQUIRED
 •Wood Stud Included
• Wood Beam Included
• Solid Concrete Included
• Cinder Block Included
•MetalStud   ContactQualiedProfessional
•Brick    ContactQualiedProfessional
•Otherorunsure?   ContactQualiedProfessional
WARNING
3 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
AB C
F
D
E JH KG I L
Description Qty. Part #
A
wallplate 1 201-1697
Btilt plate 1 201-1695
Csupport tube 2 201-1693
Dadapter bracket 2 201-1692
Erectangle cap 4 590-1334
FM8x15mmphillipsscrew 18 520-9257
GM5x8mmphillipsscrew 2 570-0005
H8mmanchor 9 590-0320
I#14x2.5woodscrew 9 5S1-015-CO3
J5/16splitwasher 18 540-9405
K5/16washer 18 540-9406
Llock bracket 2 201-1698
Parts List
4 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
Installation to Triple Wood Stud Wall
Useastudndertolocatetheedgesofthestuds.Useofanedge-to-edgestudnderishighlyrecommended.
Basedontheiredges,drawaverticallinedowneachstud’scenter.Placewallplate(A)onwallasatemplate.
Levelplate,andmarkthecenteroftheninemountingholes.Makesurethatthemountingholesareonthestud
centerlines.Drillnine5/32"(4mm)dia.holes2.5"(64mm)deep.Makesurethatthewallplateislevel,secureit
usingnine#14x2.5"woodscrews(I)asshown.
Skip to step 2.
• Installermustverifythatthesupportingsurfacewillsafelysupportthecombinedloadoftheequipmentandall
attachedhardwareandcomponents.
• Tightenwoodscrewssothatwallplateisrmlyattached,butdonotovertighten.Overtighteningcandamagethe
screws,greatlyreducingtheirholdingpower.
• Nevertighteninexcessof80in.•lb(9N.M.).
• Makesurethatmountingscrewsareanchoredintothecenterofthestud.Theuseofan"edgetoedge"studnder
ishighlyrecommended.
• Hardwareprovidedisforattachmentofmountthroughstandardthicknessdrywallorplasterintowoodstuds.Install-
ersareresponsibletoprovidehardwareforothertypesofmountingsituations.
WARNING
1
A
I
5 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
solid concrete
cinder block
Installation to Solid Concrete or Cinder Block
• WheninstallingPeerlesswallmountsoncinderblock,verifythatyouhaveaminimumof1-3/8"(35mm)ofactual
concretethicknessintheholetobeusedfortheconcreteanchors.Donotdrillintomortarjoints!Besuretomount
inasolidpartoftheblock,generally1"(25mm)minimumfromthesideoftheblock.CinderblockmustmeetASTM
C-90specications.Itissuggestedthatastandardelectricdrillonslowsettingisusedtodrilltheholeinsteadofa
hammerdrilltoavoidbreakingoutthebackoftheholewhenenteringavoidorcavity.
• Concretemustbe2000psidensityminimum.Lighterdensityconcretemaynotholdconcreteanchor.
• Makesurethatthewallwillsafelysupportfourtimesthecombinedloadoftheequipmentandallattachedhardware
and components.
WARNING
1
CUTAWAY VIEW
INCORRECT CORRECT
wall
plate
wall
plate
plaster/
drywall
plaster/
drywall
concrete concrete
1
3
2
H
Drillholesandinsertanchors(H).
Place plate (A)overanchors(H)andsecurewithscrews(I).
Tightenallfasteners.
A
H
I
concrete
surface
• Tightenscrewssothatwallplateisrmlyattached,
but do not overtighten.Overtighteningcandamage
screws,greatlyreducingtheirholdingpower.
• Nevertighteninexcessof80in.•lb(9N.M.).
• Alwaysattachconcreteexpansionanchorsdirectly
to load-bearing concrete.
• Neverattachconcreteexpansionanchorsto
concretecoveredwithplaster,drywall,orother
nishingmaterial.Ifmountingtoconcretesurfaces
coveredwithanishingsurfaceisunavoidable,
thenishingsurfacemustbecounterboredas
shownbelow.Besureconcreteanchorsdonot
pullawayfromconcretewhentighteningscrews.If
plaster/drywallisthickerthan5/8"(16mm),custom
fastenersmustbesuppliedbyinstaller.
WARNING
Makesurethatwallplate(A)islevel,useitasa
templatetomarkninemountingholes.Drillnine5/16"
(8mm)dia.holestoaminimumdepthof2.5"(64mm).
Insertanchors(H)inholesushwithwallasshownin
gure1.1.Placewallplateoveranchorsandsecure
withnine#14x2.5"screws(I).Level,thentightenall
fastenersasshowning.1.2.
H
IA
Fig. 1.1
Fig. 1.2
6 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
Securetwosupporttubes(C) to tilt plate (B)usingfourM8x15mmphillipsscrews(F),four5/16splitwashers(J),
andfour5/16washers(K).
Securefourrectanglecaps(E) to support tubes (C)asshown.
2
3
Landscape Portrait
Landscape Portrait
B
FJK
B
FJK
D
CC
Securetwoadapterbrackets(D) to support tubes (C)usingeightM8x15mmphillipsscrews(F),eight5/16split
washers(J),andeight5/16washers(K)tocreatebracketassembly.
NOTE:Besurekeyholespointdown.
E
E
FJK
FJK
D
C
C
Keyhole
Keyhole
7 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
Tomakesurebracketassemblykeyholeareproperlyalignedwithstandoffs,positionbracketassembly
ontodisplaystandoffs.
Removebracketassemblyfrombackofdisplay.
Secure tilt plate (B)ofbracketassemblytowallplate(A)atdesiredtiltangleusingsixM8x15mmphillipsscrews
(F),six5/16splitwashers(J),andsix5/16washers(K).SecureoneM8x15mmphillipsscrews(F),5/16split
washer(J),and5/16washer(K)intoslotoftiltplate(B)asshowninDetail1.
4
5
Landscape Portrait
F
J
K
F,J, and K
F
J
K
A
B
A
B
0°
5°
10°
Slot
Display
MountingSurface
NotShownforClarity
B
Detail 1
8 of 8 ISSUED: 12-18-09 SHEET #: 125-9090-4 03-24-11
Hookdisplaystandoffsintokeyholeslotsonadapterbrackets(D)ofbracketassembly.
NOTE:Makesurethatstandoffsrestatthebottomofkeyholeslotsasshownindetail2.
Securedisplaystandoffsinkeyholeusingtwolockbrackets(L)andM5x8mmphillipsscrews(G)
asshownindetail3.
6
Detail 2
Keyhole
DisplayStandoff
Detail 3
D
L
Display
G
L
MountingSurface
NotShownforClarity
Landscape
Portrait
Detail 2
Detail 3
MountingSurface
NotShownforClarity
Display
Keyhole
DisplayStandoff
L
G
L
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Peerless PANA-85WM Installation guide

PANA-85WM
Peerless
Brand
Peerless
Model
PANA-85WM
Category
Wall & ceiling mounts accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents