BlitzRCWorks A-1 Skyraider User manual

Brand
BlitzRCWorks
Model
A-1 Skyraider
Category
Remote controlled toys
Type
User manual
A-1
skyraider
02
Brief introduction----------------------------------------------------------------------------03
Specification----------------------------------------------------------------------------------03
Caution----------------------------------------------------------------------------------------- 04
Safety instruction for Li-Poly battery---------------------------------------------------05
Assembly-------------------------------------------------------------------------------------- 06
Package Contents----------------------------------------------------------------------03
Safety Precautions--------------------------------------------------------------------------04
Caution--------------------------------------------------------------------------05
Preparation Prior to Flight------------------------------------------------------------------08
Instructions for Flight----------------------------------------------------------------------------09
Center of Gravity------------------------------------------------------------------------10
Troubleshooting--------------------------------------------------------------------------------------------10
03
◆Wingspan: 1600mm (63 inch)
◆Length: 1232mm (48.5 inch)
◆Flying Weight: 2800g (99 oz)
◆Motor: Brushless Kv400 Motor
◆Propeller: 4-Paddle
◆ESC: 80A Brushless ESC w/ BEC
◆
◆Retract: 90 Degree Rotating Servoless Retracts
◆Battery: 14.8V 3200mah 20C Li-Polymer
◆Control system: 6CH 2.4GHz Radio
Servo: 4X 9g and 2X 40g
Package Contents
Specification
Thank you for purchasing A-1 Skyraider radio controlled model airplane. It’s very convenient for you to
maintain this model due to the removable horizontal tail, vertical tail and main wings. This model airplane is
a ton of fun due to the design, durable EPO material, servoless retracts, flaps and other fun features.
04
2. Warnings listed in the instructions must be read carefully and heeded.
RC aircrafts or computer flight simulator softwares.
BlitzRCworks
Safety Precautions
Caution
1. This product is not a toy. Adult supervision is required for pilots under 14 years of age.
3. This plane should only be operated by experienced and advanced pilots.
4. Improper adjustments and operation will result in crashes and damages to the model.
5. Experience is required prior to handling this product and it can be obtained by practicing with novice
1. Do not fly during bad weather conditions such as strong winds, rain or thunderstorms.
2. Never fly the model around power lines, highways, subways or any high traffic areas.
4. Do not fly where there are other flying model planes with same frequency or there
are other jamming radio waves nearby.
5. Make sure that the model, as well as the radio system, is in the good condition before flight.
7. Do not attempt to catch the plane by hand while the plane is flying.
8. This model is recommended for pilots over the age of 14 with experience. If pilot is younger
or a novice then we recommend you get assistance from an experienced model pilot.
05
Safety instruction for Li-poly batteries
1. Use the original charger. Never charge the battery at more than 1.5 A.
2. Never discharge the battery at more than 5C. Do not discharge too long as this will damage the battery.
3. For full flight time to be achieved please cycle the cells through three flights.
5. In order to maintain the voltage and ensure the life time of the battery, please recharge it if it has not
been used for more than three months.
Caution
01. Do not disassemble or reconstruct the battery.
02. Do not short-circuit the battery.
03. Do not use or leave the battery nearby a fire, stove or heated place.
04. Do not immerse the battery in water and do not get it wet.
05. Do not charge the battery nearby a fire or under the blazing sunlight.
06. Do not drive a nail into the battery, strike it by hammer or tread on it.
07. Do not impact or throw the battery.
08. Do not use a battery with conspicuous damage or deformation.
09. Do not make the direct soldering on the battery.
10. Do not reversely charge or over discharge the battery.
11. Do not reverse charge or reverse the connection.
12. Do not connect the battery to any ordinary charge socket or car cigarette jack.
13. Do not use the battery for unspecified equipment.
14. Do not touch a leaking battery directly; please wash the contact area or clothing with water
if they come in contact with the liquid leaking from the battery.
15. Do not mix the Li-Poly battery with other un-chargeable battery .
16. Do not continue charging the battery over the prescribed time.
17. Do not put the battery into a microwave oven or high-pressure container.
18. Do not use an abnormal or deformed battery.
19. Do not use or keep the battery under direct sunlight.
20. Do not use the battery where there maybe static electricity (over 64V).
21. Do not charge the battery where the temperature is under 0 or over 45.
22. If you find that the battery is leaking or shows abnormal symptoms, stop using it .
23. Keep the battery away from the children.
24. Use the specified charger and observe charging requirement (under 1.5A).
25. Parents should supervise and show the children the correct way to charge.
4. Never charge the battery on a carpet floor as this can cause a fire!
06
Assembly
rudder with screws elevator with screws aileron with screws
in the fixed position on and wheel cover on the wheel cover with screws landing gear plastic.
the main wing. wires of aileron and flap.
the servo arm.
and flap servos.
and flap then buckle them into
the horn.
13. Insert the wing rod into
4. Connect the wires of
5. Install the landing gear 6. Install the fixed holder
7. Fix the holder and
8. Tie the soft wire to the
10. Install the push rod for aileron
1. Install the horn on 2. Install the horn on 3. Install the horns on
11. Adjust the clevis of aileron
12. Glue the missiles and tanks onto the main wing.
14. Connect the extension
wire of landing gear. of tail landing gear with
15. Connect the extension 16. Connect the steel wire
9. Bind the soft wire and wheel cover.
17. Crimp the line with pliers.
landing gear.
the wing. electric retracts.
(PB2.0X30mm 4pcs). (PB2.0X15mm 4pcs). (PB2.0X15mm 8pcs).
(PA2.6X20mm 8pcs).
07
(PM3.0X40mm 2pcs).
(PM3.0X50mm 2pcs).
(PM3.0X40mm 2pcs). steel rod with the horn on
rudder.
steel rod with the horn on
the elevator.
parts on the fuselage. the fuselage.
the propeller with screw
18. Connect soft steel wire the servo arm of tail landing gear. 19. Install horizontal tail
wing on the fuselage with
screws
19. Install vertical tail wing on the fuselage with screws 20. Connect the controlling 21. Connect the controlling
22. Install main wings on the fuselage with screws 23. Glue the decorating 24. Glue the antenna on
25. Glue canopy on the
cockpit.
26. Install the propeller adapter on motor with screws and 27. Install the propeller on
nut the propeller adapter.
(HM3.0X10mm 4pcs, M8 1pcs).
28. Install the spinner on
(PM4.0X10mm 1pcs).
29. Glue the gun on the
vertical tail wing.
30. Glue the gun on the
main wing.
31.Assembly is finished!
08
Preparation Prior to Flight
closed before powering up the transmitter. Then connect the battery to the ESC of the model airplane and place the battery in its proper position.
Make sure the switch on the transmitter is in the "OFF" position. Insert the 8 AA batteries in the transmitter. Ensure that the throttle is fully
hit any person or any object and ensure to hold the airplane in place so that the model unit will not take off.
Test all joystick functions to ensure all control surfaces responds correctly. During testing, please make sure that the propeller will not
MODE 2 ONLY FOR REFERENCE !
Left stick
pushing up
Speed up
Speed down
Nose turn left
Nose turn right
descending
ascending
The body incline
to left
The body incline
to right
Left stick
pulling down
Left stick
moving left
Left stick
moving right
Right stick
pushing up
Right stick
pulling down
Right stick
moving left
Right stick
moving right
09
Instructions for Flight
Nose down/
Nose up/
10
Problem Cause Solution
Motor does not run
1. Battery is not fully charged.
2. The battery of transmitter is
not sufficient
3. Check the wire connection
inside the model
4. The motor do not work due to
impact or damage.
5. The frequency binding of the
radio system fails
4. Change a new motor
No reaction for the
control surface
1.
2.The servo is damaged
1. Check the connection of
2.Change another servo.
Can not fly straight
1.The rudder is not in the center
position of the airframe
2.The main wing is not fixed in
the center position of the airframe.
1. Adjust the trim switch on
the transmitter
2.Re-assembly the main wing
Can not climb 1. The battery is not fully charged.
2. Two aileron are biased downward
1. Charger the battery
2. Adjust the inching switch on
the Transmitter.
Limited control range Install new batteries
Throttle
Troubleshooting
2. Install a new set of batteries
1. Charge the battery.
3. Please contact your local
distributor
5. Please rebind the unit
properly or inversely inserted.
The servo wire was not inserted
the servo wire
The batteries are almost depleted.
10
The manufacturer reserve the right to modify the
specification of this product at any time without notice.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

BlitzRCWorks A-1 Skyraider User manual

Brand
BlitzRCWorks
Model
A-1 Skyraider
Category
Remote controlled toys
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents