WC-R4600-72-DBL
INSTALLATION-GUIDE
0
1
2
3
4
1
2
3
0
0
m
m
"
-
C
H
N
Prior to installation please check received
items against the “Packing List”.
Please report any missing items to your
retailer immediately.
Protect all surfaces from sharp objects,
high heat sources, direct prolonged
sunlight and chemical hazards.
Professional installation recommended.
●
●
●
PACKING LIST
REQUIRED TOOLS NOT IN BOX
INSTALLATION AND ADJUSTMENT OF HINGES (if required)
(Not all components may be included, depending on your purchase)
Sink / 1 Main cabinet / 1 24” Mirror / 2
Bracket / 4
Screw for vanity / 12
T
ape Measure
Pencil
Electric Drill
Phillips Screwdriver
Adjustable Wrench
Spirit Level
Silicone Sealant
remove adjust height adjust laterally adjust depth
install
70” Mirror / 1
WC-R4600-72-DBL
INSTALLATION-GUIDE
INSTALLATION INSTRUCTIONS
1
2
Attach the bracket by screwing into a wall stud
reinforcement.
3
Mark the position of the screw holes on the wall by
measuring the space between the centers of the mounting
brackets on the back of the vanity. Vertical position (X) is
decided by the purchaser. Remember to mark low enough
to accommodate the sink on the top of the top of the vanity
counter or it will be too high when installed. Use a spirit level
to ensure the screw holes are horizontal.
4
Attach vanity to wall by lowering onto the mounting
brackets.
5
Adjust the mounting attachment as required.
Draw horizontal line
Mark screw position
Upper screw adjusts
vertical position
Lower screw
adjusts depth
Silicone
Attach counter to cabinet with silicone sealant applied
to top of front and side cabinet edges. Do not over apply.
Allow to dry for 24 hours for proper curing.
Diameter 15/64 in.
Depth 1.57 in.
WC-R4600-72-DBL
INSTALLATION-GUIDE
(1)
(2)
(3)
7
8
6
Licensed professional installation recommended. These
instructions are for mounting into studs or other in wall
reinforcement, drywall alone is not sucient to support
wall hung vanities. Other installation techniques may
require a licensed professional.
Install the mirror: use a pencil to mark the placement of
the screw holes on the wall, drill the holes and insert the
plastic wall anchors.
Install the screws into the wall anchors, leaving enough of
the screw exposed to hang the mirror - approx. 1/4” -1/2”.
Silicone
1/4in. -1/2in.
-
1
-
2
-
3
