STRONGAR LPH-B-18-1000 Installation guide

Brand
STRONGAR
Model
LPH-B-18-1000
Type
Installation guide
Back to Back Installation
1. Drill holes at required center to center locations using the
drill size required by bolt size (Every handle varies, 3/8” to 1/2” diameter)
2. Insert the bolt through the push side of
the door to the pull side.
3. Tighten the outside pull with the bolts. Make sure
the pull is properly tightened and snug to the door face. The
bolts should be rigid before proceeding.
4. Slide the inside pull over the bolt and hold the inside
pull tight to the face of the door while tightening the set
screws.
Note : It is imperative that the set screws are rmly tightened
and that the door pull is tight against the door face so that the
set screw properly engages the head of screw.
Arrange the accesories in the correct order: DOOR | NYLON SPACER| ESCUTCHEON | COLLAR | BOLT | INSIDE PULL
DOOR | NYLON WASHER | NYLON SPACER| ESCUTCHEON | OUTSIDE PULL
Center to Center - Chart
Handle Size Center to Center
For Installation Assistance, Call 800-259-7254 • www.strongarhardware.com
Installations Instructions
Back to Back
(Glass, Wood or Metal)
Inside Pull
Set Screw
Bolts
Escutcheon
Outside Pull
Ladder Pull Handles
12 inches
16 inches
18 inches
24 inches
32 inches
36 inches
48 inches
60 inches
72 inches
6 inches
10 inches
12 inches
18 inches
26 inches
30 inches
42 inches
54 inches
66 inches
Nylon Spacer
Nylon Washer
Door
Collar
Center to Center
  • Page 1 1

STRONGAR LPH-B-18-1000 Installation guide

Brand
STRONGAR
Model
LPH-B-18-1000
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents