HomeSullivan 40E21CCHRBR Installation guide

SEAT

ASSEMBLY INSTRUCTION

MOTION CHAIR

1PC

BASE

1PC

4PCS

SCREW

M8x45MM

4PCS

FLAT WASHER

M8x16. 5MM

LOCK WASHER

M8x8.5MM

2PCS

ALU PLATE

This page lists all the contents included in the

box. Please take the time to identify the hardware

as well as the time to individual components to

this product. As you unpack and prepare for

assembly, place the contents on a carpeted or

padded area to protect them from damage.

2PCS

NUT

1PC

WRENCH

Cleaning & Care

Treat surface with care. Surface is resistant to scratches but is not scratch resistant.

Clean surfaces with a dry or damp soft doth. Do not use abrasive cleaners. Hardware

may loosen over time. Periodically check that all connections are tight.

Remove all protective packing material and position base on floor.

Attach the seat(A) onto the base(B) with Alu plate(G) as the picture,

then using screws(C), flat washers(D), lock washers(E) and nuts(F).

Be sure to the arrows face to front. Tighten all the bolts and nuts.

Test the swivel rocker gently. If the rocker does not rock properly,

double check the assembly procedure especially.

Download PDF