Legrand Video Terminator - 364412-01 Operating instructions

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET

Video Terminator

IS-0119 REV. A

1. Introduction

The On-Q/Legrand Video Terminator, P/N 364412-01

(see Figure 1) is a 75 ohm coaxial terminator used on all

un-terminated RG-6 RF video runs to eliminate any

possible interference.

2. Description

The On-Q Video Terminator provides impedance matching end-of-line 75 ohm loads for those RG-6 coaxial

RF video connections left un-terminated at installation. This impedance matching preserves picture quality

and clarity while eliminating any possible ingress interference at the connector. They are supplied as a bag of

ten individual video terminators.

3. Installation

A. For any unused RF video connections at outlets or on Video Distribution Modules which are not self-

terminating, simply screw the Video Terminator onto the unused connection until firmly in place (see

Figure 2).

Figure 1

Figure 2

This manual is also suitable for