1
2003 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
CE Decal Kit
107cm/122cm Vacuum Bagger for XT Series
GardenTractors
Part No. 107–3698
Form No. 3350–962
Installation Instructions
Installing the Decals
Install the decals in the positions indicated in the table and
graphics below. Place each International decal directly over
the corresponding US English decal.
Install each decal as follows:
1. Thoroughly clean the area where you will install the
decal.
2. Dampen the area with water or mildly soapy water.
3. Peel the decal from the backing and install it in place.
4. Squeegee across the surface of the decal, starting at the
center of the decal and working toward the edges, using
overlapping strokes.
Installing the Sound Decal on
the Mower Deck
Note: The 105 dB sound decal is installed on either the
107cm belt cover or the 132cm mower.
Install the sound decal to the correct belt cover as shown in
Figure 1.
Installing the Decals
m–7291
3
53
2
1 4
1
4
6
Front View of Bagger Hood
19mm
19mm
107cm Cover
122 cm Cover
Figure 1
1. Noise decal, 105–4674
2. Decal, 93–7814
3. Decal, 93–6658
4. Decal, 93–7317
5. Decal, 93–7316 6. Decal, 93–7320
2
Location
(See Figure 1
for the correct
location)
U.S. English International
1
No existing U.S. decal 105-4674
2
79–7450 93-7814
3
Qty. 2
79–7460 93-6658
4
92–7108 93-7317
5
93-1122 93-7316
3
Location
(See Figure 1
for the correct
location)
InternationalU.S. English
6
92–7113 (US English)
6
93–7320 (International)
4
/
