2. Computers & electronics
  3. TVs & monitors
  4. Flat panel wall mounts
  5. Mircom
  6. LT-974 RB-MD-953

Mircom LT-974 RB-MD-953 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Mircom LT-974 RB-MD-953 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
LT-974 Rev 0
September 2009
Model RB-MD-953
Replacement LCD Display & Keypad
Installation Instructions
RB-MD-953 Mounting
Unscrew the six #8-32” locknuts that hold the existing board in place. Disconnect cable from main entry panel board
and remove the display from the front door of the entry panel. Replace with new board RB-MD-953 connect the cable
and use the six locknuts to mount the replacement board in place.
Figure 1: RB-MD-953 Board Replacement
T
o replace the 4 x 20 LCD
unscrew the 6 locknuts on the
board and disconnect the
ribbon cable from the entry
main controller board. Replace
with the RB-MD-953 board,
re-connect the ribbon cable and
fasten with the 6 locknuts.
The six
locknuts
holding the
LCD and
board in
place.
/