Ditek DTK-6LVLP Series Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
This manual is also suitable for
Doc # INT-100065-001
Part No. 191120 Rev. 1
DITEK Technical Support Available 24/7
1-888-472-6100
www.ditekcorp.com
DITEK Corporation
ONE DITEK CENTER
1720 Starkey Road
Largo, FL 33771
INSTALLATION
INSTALL INSTRUCTIONS
DTK-6 & 8LVLP SERIES
LOW VOLTAGE LINE PROTECTION
NOTE: THESE DEVICES ARE INTENDED FOR INDOOR USE ON LOW
VOLTAGE TELECOMMUNICATIONS SYSTEMS
1. Before beginning installation, make sure the power is off.
2. This device must be connected in series between the field wiring and the
equipment to be protected.
3. Securely mount the base close to the circuit being protected using the
double sided tape (supplied), or two #8 screws (not supplied).
4. Make sure the wire distance from the surge protector to protected
equipment is greater than the wire distance from the surge protector to ground.
5. Use one common ground per system to eliminate the possibility of a
difference in ground potentials.
6. Connect side #1 "in" with the incoming field wires, and connect the opposite
side of the terminal block to the equipment to be protected.
7. After all connections have been made and no hazards exist, restore power.
8. If you have any questions call technical support at: 1-888-472-6100.
OPPOSITE SIDE: #1 "IN" FROM FIELD WIRING
LABEL SIDE: "OUT" TO PROTECTED EQUIPMENT
MODEL:
DTK- 6LVLP -GP
-GP
LOW VOLTAGE
SURGE PROTECTION
DTK- 8LVLP
DTK- Z8LVLP
DTK- Z6LVLP
6
D
14
X
30
LV
50
OPX
75
SPK
95
SGR
130
RUV
SUFFIX
VRMS
-SCP -SCP
MODEL
DTK-Z6LVLP
DTK-Z8LVLP
# WIRES
PROTECTED
12 WIRES
16 WIRES
VOLTS RMS
6.8
FOR USE ON RS422/RS485 SYSTEMS
-
1
Ditek DTK-6LVLP Series Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ditek DTK-TSS1 User manual
-
-
-
-
-
-
-
-
-