Sunricher SR-2807 User manual

  • Hello! I have reviewed the provided user manual for the Sunricher Remote Controller 09.2807S.04134. This document outlines the features, operation, pairing instructions, and safety warnings for the device. It also details how to use the remote to control lighting intensity, and pair with RF receivers. I am ready to answer any questions you might have about the remote controller.
  • What type of battery does the remote use?
    How many remote controls can be paired with one receiver?
    How to pair remote with RF receiver?
    How to delete the pairing?
RF Single Color Remote Controller
Click to turn on/off,
Press and hold down to increase/
decrease light intensity
09.2807S.04134
Operation
1. Pair with RF receivers:
2. How to delete the pairing:
Press and hold down “Learning Key” on the receiver for over 3 seconds until connected LED lights flicker twice,
which means the pairing is deleted successfully.
Click “Learning Key”
on RF receiver
Function introduction
Important: Read All Instructions Prior to Installation
Output RF signal
Operation Frequency 868/915/434MHz
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 32x32x9.8mm
Front side
Back side
Product Data
This device contains a button lithium battery that shall be stored and disposed properly.
DO NOT expose the device to moisture.
Safety & Warnings
Power Supply 3V(CR2025 battery)
Click button
on RF remote
LED lights connected with the
RF receiver will flicker once
square circular
LED indicator
If the remote is out of power,
you can open the back cover and replace the battery(CR2025).
Control 1 zone
• Single color controller
• Memory Function
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
The receiver is paired with
remote successfully.
/