Angelo Decor AD40035 is a solar-powered water pump and LED light system ideal for fountains and ponds. It features a 1.4W solar panel that charges the 4 included batteries, providing up to 4 hours of operation per day. The pump has a maximum water lift of 0.5 meters and a maximum flow rate of 150 L/H, making it suitable for small to medium-sized fountains. The LED light operates on a sensor, automatically turning on at night. The system is easy to install and use, with a simple on/off button and memory function that allows you to set a daily operation time.
Angelo Decor AD40035 is a solar-powered water pump and LED light system ideal for fountains and ponds. It features a 1.4W solar panel that charges the 4 included batteries, providing up to 4 hours of operation per day. The pump has a maximum water lift of 0.5 meters and a maximum flow rate of 150 L/H, making it suitable for small to medium-sized fountains. The LED light operates on a sensor, automatically turning on at night. The system is easy to install and use, with a simple on/off button and memory function that allows you to set a daily operation time.
SOLAR HYBRID PUMP
USER’S MANUAL AD40035
1. BEFORE YOU BEGIN – ASSEMBLY
Unpack all components carefully.
Install the 4 batteries (supplied), in proper orientation (+/-), in the
housing at rear of solar panel. Be sure the cover closes properly.
Fully charge the unit using either direct sunlight (minimum 6 hours)
or the hybrid charging unit plugged into an indoor power receptacle.
2. PREPARATION FOR USE, For FOUNTAINS
Install the pump in the founta
in reservoir area ensuring it is
completely submersed in water.
Connect the pump cable to the socket of the control housing on the
rear side of the solar panel.
Connect the optional LED light cable to the socket of the control
housing. (If required)
Choose an appropriate location for the solar panel that will
allow the best possible exposure to sunlight.
3. PREPARATION FOR USE, For PONDS
¾ Choose the style of fountain head as needed, and number of
extension tubes required for proper height.
¾ Connect fountain head and/or LED light to the extension tube.
¾ Connect the pump cable to the socket of the control housing on the
rear side of the solar panel.
¾ Connect the LED light cable to the socket of the control housing.
¾ Place the pump under water, ensuring it is fully submersed. Adjust
height of unit so fountain head is just above the water surface.
¾ Choose an appropriate location for the solar panel that will
allow the best possible exposure to sunlight.
¾ The unit is now ready to use.
4. OPERATING INSTRUCTIONS
Turning on / off the pump system
Push the “on” button at rear of solar panel. The green “pump on” light will
illuminate, automatically setting memory function for daily use at this time.
:
(Note: LED lights use a sensor, operating only at night)
Low Battery
When the battery is low, the red “low battery” indicator light will blink.
Allow the solar panel to charge the batteries for at least 4 hours in full
direct sunlight, or unplug pump and light from the rock unit and charge
using the hybrid charging cable.
:
When you push the “on” button, the system will work for up to 4 hours,
or until the battery power is exhausted.
Proper Use of the Memory function
Note the time. The pump will begin operation automatically at this
time every day unless you clear the memory.
Pushing the “off” button will clear the memory. The next time the “on
button” is pushed, the system resets to this new time daily.
5. CLEANING AND MAINTENANCE
Solar panel: The panel should be cleaned periodically with a soft tissue.
Regular cleaning of the panel is advised to maintain optimum conversion
of the sun’s energy into direct current.
Pump: To prevent build up of sediment, scale or dirt in the impeller or
filter, remove the pump cover and the impeller cover. Clean parts with a
soft brush, and mild soap and water.
6. REPLACING BATTERIES
The rechargeable batteries are intended for a life span of up to 18
months based on proper usage. They can be replaced with
4 standard 1.2V / 1200mAH AA size Ni-MH units.
CAUTIONS / WARNINGS
Any alteration of the product or the components will void warranty.
Do not connect the pump directly to any AC voltage power; it is
intended ONLY for DC Voltage power.
The Hybrid Charging Cable is intended for INDOOR USE ONLY.
Operate in freshwater only (never above 50 degrees C ),
Keep away from flammable liquids.
Do not strike the solar panel.
Do not let the pump run dry.
3. PREPARATION FOR USE, For PONDS
¾ Choose the style of fountain head as needed, and number of
extension tubes required for proper height.
¾ Connect fountain head and/or LED light to the extension tube.
¾ Connect the pump cable to the socket of the control housing on the
rear side of the solar panel.
¾ Connect the LED light cable to the socket of the control housing.
¾ Place the pump under water, ensuring it is fully submersed. Adjust
height of unit so fountain head is just above the water surface.
¾ Choose an appropriate location for the solar panel that will
allow the best possible exposure to sunlight.
¾ The unit is now ready to use.
4. OPERATING INSTRUCTIONS
Turning on / off the pump system
Push the “on” button at rear of solar panel. The green “pump on” light will
illuminate, automatically setting memory function for daily use at this time.
:
(Note: LED lights use a sensor, operating only at night)
Low Battery
When the battery is low, the red “low battery” indicator light will blink.
Allow the solar panel to charge the batteries for at least 4 hours in full
direct sunlight, or unplug pump and light from the rock unit and charge
using the hybrid charging cable.
:
When you push the “on” button, the system will work for up to 4 hours,
or until the battery power is exhausted.
Proper Use of the Memory function
Note the time. The pump will begin operation automatically at this
time every day unless you clear the memory.
Pushing the “off” button will clear the memory. The next time the “on
button” is pushed, the system resets to this new time daily.
5. CLEANING AND MAINTENANCE
Solar panel: The panel should be cleaned periodically with a soft tissue.
Regular cleaning of the panel is advised to maintain optimum conversion
of the sun’s energy into direct current.
Pump: To prevent build up of sediment, scale or dirt in the impeller or
filter, remove the pump cover and the impeller cover. Clean parts with a
soft brush, and mild soap and water.
6. REPLACING BATTERIES
The rechargeable batteries are intended for a life span of up to 18
months based on proper usage. They can be replaced with
4 standard 1.2V / 1200mAH AA size Ni-MH units.
CAUTIONS / WARNINGS
Any alteration of the product or the components will void warranty.
Do not connect the pump directly to any AC voltage power; it is
intended ONLY for DC Voltage power.
The Hybrid Charging Cable is intended for INDOOR USE ONLY.
Operate in freshwater only (never above 50 degrees C ),
Keep away from flammable liquids.
Do not strike the solar panel.
Do not let the pump run dry.
7. TROUBLE SHOOTING
(a) Pump does not operate when solar panel is in full sunlight.
Check: All Wiring and connections from pump to the solar panel.
Check: If Impeller is blocked with debris, clean the pump as described in
previous section.
(b) Pump does operate but there is no water running through the
fountain head.
Check: Build up of sediment or scale in the tubes or the filter.
Clean the tubes and the filter.
(c) Operating time is shorter than preset
time.
Not enough electricity stored in the batteries. Charge properly.
8.
TECHNICAL DATA
Item Number AD40035
Solar panel 1.4W
Pump Operation Voltage DC 6V
Maximum Water lift 0.5 meter
Maximum Flow Rate 150 L/H
LED light Operation Voltage DC 6V
WARRANTY
Pump is covered by a one year limited warranty
Solar Panel is covered by a one year limited warranty.
Batteries and Lights are covered for 90 days.
For more information on our solar items, please visit our web site:
www.angelodecor.com
To contact us regarding this unit, your options include:
Email: info@angelodecor.com
Phone: 780 – 453 6646
Fax: 780 – 453 6620
-
1
-
2
-
3
-
4
Angelo Decor AD40035 is a solar-powered water pump and LED light system ideal for fountains and ponds. It features a 1.4W solar panel that charges the 4 included batteries, providing up to 4 hours of operation per day. The pump has a maximum water lift of 0.5 meters and a maximum flow rate of 150 L/H, making it suitable for small to medium-sized fountains. The LED light operates on a sensor, automatically turning on at night. The system is easy to install and use, with a simple on/off button and memory function that allows you to set a daily operation time.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Angelo Decor AD93116 Operating instructions
-
-
-
-
-
-
-
-
-
Other documents
-
Aquagarden SolarFree 800C Supreme User manual
-
Annin Flagmakers 2472 User manual
-
Sharper Image Solar Color-Changing Water Fountain User manual
-
AQUATECH PondMax Ultra Series User manual
-
Sunnydaze Decor AMP-P002C Installation guide
-
-
Koolatron CSFK-5 Operating instructions
-
-
Harbor Freight Tools Solar Powered Fountain Pump User manual
-
AquaPRO AP400s User manual
