Harbor Freight Tools Solar Powered Fountain Pump User manual

Brand: Harbor Freight Tools

Model: Solar Powered Fountain Pump

Type: User manual

SOLAR POWERED FOUNTAIN

PUMP

66093

SET UP AND OPERATING INSTRUCTIONS

Distributed exclusively by Harbor Freight Tools

3491 Mission Oaks Blvd., Camarillo, CA 93011

Visit our website at: http://www.harborfreight.com

Read this material before using this product.

Failure to do so can result in serious injury.

SAVE THIS MANUAL.

2008 by Harbor Freight Tools

contained herein may be reproduced in any shape or form without the express written consent of

Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing

improvements, actual product may differ slightly from the product described herein. Tools required for

assembly and service may not be included.

For technical questions or replacement parts, please call 1-800-444-3353.

SKU 66093 For technical questions, please call 1-800-444-3353. Page 2

Before start-up, note the following:

CAUTION

This pump has been designed for use

with water only.

WARNING

Circulation of caustic uids, as well 1.

as the circulation of abrasive materi-

als, must be avoided at all costs.

The pump must be protected from 2.

frost.

The pump must be protected from 3.

running dry.

Access by children should also be 4.

prevented with appropriate mea-

sures.

WARNING: Handling the Power Cord 5.

on this product will expose you to

lead, a chemical known to the State

of California to cause cancer, and

birth defects or other reproductive

harm. Wash hands after handling.

(California Health & Safety Code §

25249.5, et seq.)

The warnings, precautions, and in-6.

structions discussed in this instruction

manual cannot cover all possible con-

ditions and situations that may occur.

It must be understood by the operator

that common sense and caution are

factors which cannot be built into this

product, but must be supplied by the

operator.

Fluid Type

The Pump is designed for use with

water with a maximum temperature of 77°

F (25°C). Do not use the pump for other

uids, especially not fuels, cleaning uids,

or other chemical products.

SPECIFICATIONS

Maximum Water Lift 2.62 Feet

Solar Panel Peak

Power

1.2 Watt

Maximum Flow Rate 42 GPH

Maximum Water Jet

Height

9 Inches

UNPACKING

When unpacking, check to make sure

that the item is intact and undamaged. If

any parts are missing or broken, please

call Harbor Freight Tools at the number

shown on the cover of this manual as soon

as possible.

INSTALLATION

Use the Nozzle Adapters and Exten-1.

sion Tubes to construct a tube that

will rise one to three inches above the

surface of the water.

The Nozzle Adapters, Extension 2.

Tubes, and Fountain Heads, can be

assembled in a variety of different

ways to construct the length of tube

and desired spray pattern that suits

the needs of the fountin best.

Push the tube onto the top of the 3.

Pump.

Press a Fountain Head on top of the 4.

tube.

Route the cord of the Pump to an 5.

area that receives consistent sunlight.

SKU 66093 For technical questions, please call 1-800-444-3353. Page 3

Place the Pump on the bottom of the 6.

fountain and push down lightly so that

the suction cups grip.

Extension

Tubes

Fountain Head

Nozzle

Adapter

Submersible

Pump

Fill the fountain with water. If the 7.

water level sinks too low, any sludge

in the shaft will dry out and may stop

the pump from starting.

Attach the Solar Panel to the cord of 8.

the Pump and place it on a level sur-

face that recieves steady sunlight.

While there is a steady supply of sun-9.

light the Pump will operate.

MAINTENANCE

TO PREVENT

SERIOUS INJURY

FROM ACCIDENTAL

OPERATION:

Unplug the Pump from the

Solar Panel before performing

any inspection, maintenance,

or cleaning procedures.

BEFORE EACH USE,1. inspect the

general condition of the unit. Check

for misalignment or binding of moving

parts, cracked or broken parts, dam-

aged wiring, and any other condition

that may affect its safe operation.

PERIODICALLY, 2. remove the cover

of the Pump and clean out the intake

vents. Remove the cap on the Pump

to clean out the impeller.

Cap

Cover

Impeller

AFTER USE,3. ush with clean water

and clean external surfaces of the

tool with clean cloth.

SKU 66093 For technical questions, please call 1-800-444-3353. Page 4

Record Product’s Serial Number Here:

Note: If product has no serial number, record month and year of purchase instead.

Note: No replacement parts

PARTS LIST

Part Description Qty

1 Submersable Pump 1

2 Solar Panel 1

3 Fountain Head (three shown) 4

4 Nozzle Adapters 3

5 Extension Tubes 4

DIAGRAM

Harbor Freight Tools Solar Powered Fountain Pump User manual

Harbor Freight Tools Solar Powered Fountain Pump User manual

Harbor Freight Tools Solar Powered Fountain Pump User manual

Related papers

Other documents