Barco service bulletin
Serial Number: 1316
Date: 09/01/2017
Product: EX Expansion box
Priority code*: C
A.
”Must” modification, Barco will provide the necessary components to perform this modification
at no charge.
B.
Improves the reliability of the product.
C.
Improves the general working conditions of t he pr odu ct.
D.
For information only.
1. OPTIMIZING EVENT MAST ER INPUT -CA RD
INSTALLATION IN THE EX EXPANSION BOX
1.1 General
Phenom enon
The L ED wires, or the wire zip tie, on an Event Master input card can come into contact
with elements of the printed circuit board assembly (PCBA) of the main board, if the Event
MasterinputcardisinstalledinSlot1.
Image 1-1
LED wires and zip tie
Solution
Install a single Event Mas ter input card in Slot 2. If two E vent Master input car ds are to be
installed, make sure that the LED wires are pressed as far toward the Event Master input
card PCBA as is possible. It may also be necessary to rotate the zip tie for the LED wires
so that it does not contact the components on the main board PCBA.
Barco Inc, Image Processing
3078 Prospect Park Drive, Rancho Cordova, CA , 95670, USA
www.barco.com
Page 1 of 3