Torch Instruction Sheet
Before assembly, check to see that all parts are present.
Tools needed: hammer and a block of wood.
1) Using the block of wood as a buffer, hammer the pointed
end of the ground post securely into the ground, leaving
approximately 6 inches exposed above the ground.
2) Attach the base post (straight tube) to the secured
ground post.
3) Attach the first fluted post, inserting the smaller end into
the base post. Attach the second fluted post, inserting the
smaller end into the first fluted post.
4) Insert the wire torch holder into the top fluted post.
5) Fill the torch with torch fuel, up to 1/2” below the top
of the torch. Let the wick soak up fuel for 2 to 3 hours
before lighting.
6) Place torch in wire torch holder.
7) Remove snuffer cap and light with a match or lighter.
8) Place snuffer cap over wick to extinguish flame.
DANGER
Failure to follow Danger statements can cause a fire or
explosion resulting in serious bodily injury or death, or
damage to property.
DANGER
For outdoor use only.
Use only commercially manufactured torch fuel and follow
manufacturers directions for use and storage.
Never use gasoline, alcohol or any volatile fuel.
Keep children and pets away from the torch.
The torch has an open flame, do not use near combustible
materials.
Never use the torch unless it is in the wire torch holder.
Use only the snuffer cap to extinguish flame.
Parts
Wick
Wick Holder
Snuffer Cap
(with chain
already attached)
Torch body
Wire Torch Holder
Fluted Post
Fluted Post
Base Post
Ground Post
Note: Keep snuffer cap on when torch is not in use to prevent contamination
of fuel.