10. Use the right Tiki Torch for the job. There are certain applications for which this Tiki Torch
was designed. Do not modify this product and do not use this Tiki Torch for a purpose for
which it was not intended.
11. Avoid using alone. If an accident happens, an assistant can bring help.
12. Do not overreach. Keep proper footing and balance at all times. Do not reach over or
across the Tiki Torch. Be aware that parts of the Tiki Torch will become very hot during
operation, and for a period of time after use.
CAUTIONS FOR OPERATING
1. The Tiki Torch is designed for outdoor use only. Do not use this product in a trailer,
tent, house, garage, or any enclosed area because carbon monoxide may accumulate;
carbon monoxide is a colorless, odorless gas that when inhaled may cause serious
injury or death.
2. Always use the Tiki Torch in an open area away from buildings, dry leaves or brush.
Be aware of wind blown sparks.
3. Avoid high pedestrian traffic areas. Do not allow people or pets to conduct any activity
near the Tiki Torch while the unit is in use, or following its use. The Tiki Torch Fuel Can is hot
during use, and will remain hot for a period of time after use.
4. Use only the appropriate Citronella or lantern oil. Never use gasoline, kerosene, or other
highly volatile fluids as a starter or as fuel, as they can explode.
5. Make certain all parts of the Tiki Torch are firmly in place and that the Tiki Torch is
positioned on a flat, level, fire retarding surface.
6. Never leave the Tiki Torch unattended while lit.
7. Do not clean the Tiki Torch with cleaners that are combustible or corrosive.
8. Make certain that the Fuel Can is disconnected from the unit when the Tiki Torch is
not in use.
9. Never smoke while attempting to light the Tiki Torch. Make sure all surrounding flames
are extinguished.
10. Do not use or store any flammable liquid or material in the area surrounding the Tiki
Torch.
Assembly
Your Tiki Torch will require some simple assembly as described in the following steps. To assist you
with assembly and operation please refer to the Operational Figures as well as the Assembly
Diagram and Parts List located on the last pages of this manual.
1. Attach Pole (4a) to Pole (4b). Insert Stake (5) onto bottom Pole (4b).
SKU 91536 Page 3