2. Home
  3. Home security & automation
  4. Security camera accessories
  5. i3 International
  6. B7

i3 International B7 Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the i3 International B7 Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
DIMENSIONS
Quick Start Guide
Back Box Mounting Base
B7
The B7 is an extension back box for cable management and can be used for surface,
pendant or horizontal wall mounting of i3’s Ax47/57/67R and Ax46/66R camera series.
• Back box for IP Camera Wire Management
• Suitable for outdoor and indoor installations
• Six (6) pre-drilled hole dimples for surface mounting
• Optional use with Pendant Mount EMT Pipe 3/4” or DB60 Horizontal Wallmount bracket
PACKAGE CONTENTS
Ensure that the items received match those listed on the order form and the packing slip.
In addition to this manual and B7 back box, the packing box includes:
1. Round head screw, machine type x3
2. Round head screw, tapping type with O-ring x3
3. Plastic anchor x3
i3-TRNG-CAMS-B7-QSG.indd
Rev. 180802
i3 INTERNATIONAL INC.
1.866.840.0004
www.i3international.com
Canada 780 Birchmount Road, Unit 16,
Scarborough, ON, M1K 5H4
U.S.A 4450 Witmer Industrial Estates Unit 4
Niagara Falls, NY 14305
Pendant Mount
Rigid 3/4” EMT Pipe
(Optional)
B7 Back Box
DB60 Goose Neck
Wallmount Bracket
(Optional)
Add Sealant
Alignment
marks
Align holes
Ax47/57/67R
Camera
Ax47/57/67R
Lexan dome
bubble
Important:
In outdoor installations, add silicone to the DB60 Goose neck bracket or EMT
pipe threads (if using) and tighten the provided tapping screws to fully compress the ‘O’ ring.
1. Install B7 for surface, pendant, or horizontal wall mounting, as required.
2. In indoor surface installations, position the side 3/4” thread (A) to the rear or to the
top. In outdoor installations, position the side 3/4” thread (A) to the bottom, to aid in
weather-proong.
3. B7 comes with six (6) 90% pre-drilled hole dimples. For surface mounting, complete
drilling a minimum of two holes.
4. Pull the camera’s CAT5/6 cable into the B7 housing, feed into the waterproof connector
(not supplied) and attach RJ45 connector.
5. Camera mounting holes (alignment marks) are identied on the lip of the B7 back box
with triangles (x3) for the Ax47/57/67R and Ax46/66R cameras.
3
1
INSTALLATION INSTRUCTIONS
• It is the installer’s
responsibility to ensure
that the mounting surface
is suitable for the chosen
installation method.
• Based on installation
location and surface
type, supplied mounting
hardware may be
inadequate.
• Mounting hardware is
site-specic and may
need to be supplied by
the installer.
IMPORTANT
3/4” Electrical
EMT Conduit
Fitting
2
3/4” NPS (A)
Height
1
9
/
16
”
(39 mm)
Diameter
4½”
(114.3 mm)
3/4” NPS (B)
/