Gleason Reel W5S-SK Swing Boom Stop for 50 lb. Capacity Jibs and Booms Installation guide

Gleason Reel
Brand
Gleason Reel
Model
W5S-SK Swing Boom Stop for 50 lb. Capacity Jibs and Booms
Type
Installation guide
INTRODUCTION:
The Model W5S-SK Swing Boom Stop mounts beneath the
bracket which supports the swing boom on the 50 pound
capacity tool jib. Hex stops on the mounting plate may be
adjusted to limit boom swing to 15O, 30O, 45Oor 60Oin either
direction (total swings of 30O, 60O. 90O& 120O). With no hex
stops installed the boom will swing 90Oin either direction.
Only standard wrenches are required for installation.
INSTALLATION:
1. Become familiar with drawings (right). There is no need to
remove boom from column when installing boom stop.
2. Hook mounting plate onto underside and back of boom
pivot bracket. Lay clamp plates atop bottom flange of pivot
bracket and align holes with holes in mounting plate.
3. Insert bolts with flat washers through clamp plate and mounting plate. NOTE: Bolts go beside, not through, pivot bracket. Secure
assembly with nuts, lock washers and flat washers. Make sure mounting plate is properly aligned, with hooks tight against boom
pivot bracket. Securely tighten bolts.
4. Determine where you want the boom to stop. Insert the shoulder ends of the hex boom stops into the appropriate 1/2" hole.
Secure with bolt, lock washer and flat washer.
5. Install stop bracket to underside of boom. Stop bracket is held in place by a clamp bar inside of boom. Remove end cap, end
stop and trolley. Slide stop bracket clamp bar into end of boom. Replace trolley, end stop and end cap.
6. Position stop bracket so it contacts hex stops when boom is swung. Securely tighten bolts.
7. Adjust entire assembly for best performance and check to make sure all bolts are tight. NOTE: Turn hex boom stops so that side
of hex contacts stop bracket squarely.
INSTALLATION INSTRUCTIONS
MODEL W5S-SK SWING BOOM STOP
600 S. Clark St.
Mayville, WI 53050
Phone: 920-387-4120
Fax: 920-387-4189
p/n 63012202.a
HUBBELL
®
Workplace Solutions
STOP
BRACKET
MOUNTING
PLATE
MOUNTING
PLATE
U-BOLT
BOOM
PIVOT
BRACKET
SWING
ADJUSTMENT
HOLES
COLUMN
BOOM
BOOM SWING
EACH DIRECTION
FROM CENTER
HEX
BOOM
STOP
CLAMP BAR
(inside
boom)
HEX
BOOM
STOP
RETAINER
PLATE
STOP
BRACKET
BOOM
RETAINER
PLATE
15O
30O
45O
60O
15O
30O
45O
60O
  • Page 1 1

Gleason Reel W5S-SK Swing Boom Stop for 50 lb. Capacity Jibs and Booms Installation guide

Gleason Reel
Brand
Gleason Reel
Model
W5S-SK Swing Boom Stop for 50 lb. Capacity Jibs and Booms
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents