2. Front Runner
  3. ECOM103

Front Runner ECOM103 Installation guide

  • Hello, I have analyzed the user manual for the Front Runner ECOM103 Wiring Harness. This document includes installation instructions, important safety warnings, and a brief description of the harness components such as the on/off switch, relay, fuse holder, battery connectors and ATP plug. I am ready to help you with any questions you may have about this product.
  • Where should the on/off switch be mounted?
    Where should the relay be mounted?
    Who should perform the electrical work?
1
ECOM103_REV_A00
Single LED Wiring Harness
with ATP Plug
ECOM103
INSTALL TIME: 60 min
s
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR
VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY
INJURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER
PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE
PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE
INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO
NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT
THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A
PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
2
ECOM103_REV_A00
It is advised that all electrical work and connections be done by a qualified auto electrician.
Single LED Wiring Harness with ATP Plug
A
TP Plug: Connection between
harness and light bar.
Battery Connectors:
Connect to positive and ground
battery terminals.
Fuse Holder
Relay: Mount in an appropriate
position close to battery.
Electrical Connector:
Connect ECOM095 remote control here.
ON / Off Switch: To be mounted
into your vehicles dashboard or control
panel in your desired position.
/