Vivo V001JB Pneumatic Arm Single Monitor Desk Mount User manual
- Category
- Flat panel desk mounts
- Type
- User manual
This manual is also suitable for
Pneumatic Arm Single Monitor Desk Mount
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/stand-v001jb
SKU: STAND-V001JB
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST
2
PACKAGE CONTENTS
A (x1)
Clamp and
Pole
B (x1)
Spring Arm
C (x1)
Extension
Arm
J (x4)
M4x12
D (x1)
Plastic Cap
E (x1)
Cable Clip
F (x1)
M6x25
G (x1)
3mm Allen Key
H (x1)
5mm Allen Key
I (x4)
M4x8
K (x4)
M4x30
WARNING!
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR
STAND.
• USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
L (x4)
Plastic Spacer
NOTE: SOME HARDWARE MAY NOT BE USED
3
ASSEMBLY STEPS
STEP 1
TOOLS NEEDED
13.2lbs
(5.99kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
Phillips
Screwdriver
Loosen the clamp screw on Clamp and Pole (A)
until opening is large enough to fit the edge of the
desk. If the pole is loose in the base, twist the pole
clockwise to tighten, then use the 3mm Allen Key
(G) to tighten the set screw on the back of the base
to lock the pole.
STEP 2
Place the Pole and Clamp (A) on the edge of the desk and tighten the clamp screw until securely
mounted. If needed, the 5mm Allen Key (H) can be used to tighten the clamp screw. If the clamp is
unable to open enough to fit the desk, remove the clamp screw from the base. Remove the bottom
place and re-attach upside down, then re-insert the clamp screw.
4
STEP 3
Adjust the locating ring to required height and tighten to support the arm.
STEP 4
Slide the extension arm (C) onto the steel pole (A) until the arm (C) rests on top of the locating ring.
5
STEP 5
OPTION A: Flat Back Monitor
Use four M4x8 screws (I) or M4x12 screws (J) to secure the Spring Arm (B) to the monitor via mounting
holes.
OPTION B: Curved Back Monitor
Place four plastic spacers (L) between the Spring Arm (B) and the monitor, then use four M4x30 screws
(K) to secure the Spring Arm (B) to the monitor via mounting holes.
6
STEP 6
Carefully place the spring arm (B) with the monitor onto the extension arm (C), and secure using the
M6x25 spring bolt (F) and Plastic Cap (D).
STEP 7
Use the 5mm Allen Key (H) to adjust the spring tension inside the arm (B) depending on the weight of
your monitor. NOTE: Turn counter-clockwise to reduce tension for lighter monitors and clockwise to
increase tension for heavier monitors.
7
STEP 8
Use the 3mm Allen Key (G) to adjust the arm swivel joints, and the 5mm Allen Key (H) to adjust the
monitor swivel joint. Turn counter-clockwise to loosen and clockwise to tighten.
STEP 9
Insert the monitor cables into the cable covers on the underside of the arm (B). Leave enough slack to
allow full adjustment and motion of the arm. Use the cable clip (E) to fasten cables to the steel pole (A).
S=3mm
S=3mm
S=5mm
S
=
5
m
m
LAST UPDATED: 03/05/2020
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Vivo V001JB Pneumatic Arm Single Monitor Desk Mount User manual
- Category
- Flat panel desk mounts
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Vivo CHAIR-S01P Assembly Instructions
-
-
-
Vivo STAND-V000S Assembly Instructions
-
-
-
-
-
-
