Glasswool and mineral fibre products
are NOT supported.
Installation Guide
EQ Corner Bracket Wall:Ceiling
Doc Code:
IG-CBWC
Supported Products
Page 1 of 2
All contents (c) 2018
www.eqacoustics.com
Spectrum 2.0 Tiles and Bass Traps
Including:
NOTE: We cannot guarantee the supplied fixings
are suitable for all ceilings. We recommend you
consult a professional before you proceed.
L5 Tile
L10 Tile
L10 Bass Trap
L10C Corner Bass Trap
68 mm
200 mm
200 mm
68 mm
200 mm
200 mm
Connect the panel bars to the back of the panel as shown in drawings and
L5 Tile
L10 Tile
L10 Bass Trap
Once the panel bar is fixed to the panel, attach the slide bar and strut as shown below.
Ensure the fixings mirror each other with the strut on the outer sides.
3 No. spacers on slide bar; 2 No. on panel bar
L10C Corner Bass Trap
Package Contents
2 No. Assemblies,
Supports 1 Panel.
For Larger or custom panels you may need to increase the number of fixings
2 x Mounting Bracket
4 x
2 x Slide Bar
2 x Strut
2 x Panel Bar
4 x Hinge Screws
4 x Strut Screws
6 x Panel Bar Screws
10 x Spacers
4 x Mounting Screws
Version 1.1
1
A
B
A
B
2
Self Drilling
Plasterboard Plugs
EQ Corner Bracket Wall:Ceiling
Doc Code:
IG-CBWC
Page 2 of 2
All contents (c) 2018
www.eqacoustics.com
Fix the mounting brackets to the ceiling using the
relevant hole centre measurements for your panel. Make
sure the orientation is as shown to the right.
L5 Tile, L10 Tile and L10 Bass Trap
(a) = 311mm from wall
(b) = 286mm from wall
L10C Corner Bass Trap
(a) = 170mm from wall face
(b) = 145mm from wall face
668 mm
(a)
(b)
When mounting the panel tilt the top back towards you
in order to see the slide bars and align them with the
mounting brackets channels.
4
5
Tilt the panel forward so that the slide bars can
easily slide into the channel then push the panel
back until it meets the wall.
6
7
Dotted lines indicate
screw hole centres
/
