Press the On/Off button to switch on the appliance.
cycle and operate the dishwasher according to the original Power-on state.
If the appliance is switched off during a wash cycle, when switched on again, please re-select the washing
Scrap off any large amount of leftover food.
Soften remnants of burned food in pans, and then load the baskets.
Refer to the section entitled “Preparing and Loading Dishes”.
Turn on the water tap. The appliance will start working after 10 seconds.
1.Press the start/pause button to stop the washing.
2.Open the door a little.
3.After the spray arms arm stop working, you can open the door completely.
4.Add the forgotten dishes.
5.Close the door.
6.Press the start/pause button, the dishwasher will run after 10 seconds.
1.A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2.Press the start/pause button to stop the washing, and then press the program button for more than 3
seconds to cancel the sunning program.
3.Select a new program.
4.Restart the dishwasher.
When the working cycle has finished, it stops. Turn off the appliance using On/Off button.