Highpoint RocketStor 6674T Installation guide

Page 7/13/2018

RS6000SRK Setup Guide

This Guide will provide step by step instruction on how to set the RS6000SRK on to the RS6674T

1. Lay the Rail Kit flat on a table

2. Pull on the smallest Rail all the way out until it is fully extended

3. Once it is fully extended find the small tab. Slide the tab to the right to allow the part to slide out

4. Attach the part to the side of the RS6674T enclosure. Keep the tabs on the outer side. Please line up the

holes than slide the Rail towards the rear side to lock the Rail into place.

Page 7/13/2018

RS6000SRK Setup Guide

5. Install the small screw on the left of 3

peg.

6. Install the other Rail Kit onto the Rack. The 3 holes are in the front and the 2 will be in the rear. The rear

side is also marked on the Rail Kit. Only screw in the top and bottom holes in the front.

7. Slide the rest of the Rail Kit back on the Rail. Once the Rail is on slide the tab to the left to allow the rest

of the Rail to slide in.

8. Optional Step: Once the Rail is all the way in get one of the screws and washer and insert it into hole in

the front to lock the RS6674T in.