Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1 | P a g e
Core Sync – Interface Module
Modules must be installed by a qualified electrician.
(Check with local and national codes for proper installation)
1. Caution: Observe precautions for handling electrostatic sensitive sensors.
2. WARNING: Risk of electric shock. Do not handle energized module with wet hands or when standing
on wet or damp surfaces.
3. WARRANTY: Voided if module has been modified from original configuration.
4. Suitable for damp locations.
5. Do not use Outdoors.
6. Use only with Class 2 Power Unit – 60VDC maximum.
7. Conforms UL 60730-1, CAN/CSA-E60730-1.
8. Suitable for Use in Other Environmental Air Space (Plenums) in accordance with Section 300.22, (C) of
the National Electrical Code
9. This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
10. Maximum temperature is 30°C ambient.
11. Input: PoE voltage range of 42-57V.
12. For CSA, device is intended to be installed in a restricted access area.
13. The mounting pattern for the module is below:
987652-1032
Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2 | P a g e
14. Snap in the wire harness male connector into the female connector as shown below. The connector
from the Gateway side must plug into the INPUT connector:
**Warning** Input and output connections are not interchangeable. While no damage will
occur if the connections are switched, the device(s) will not function properly
15. The other end of the wire harness goes into a Gateway, if it is a 5x2 connector (Molex part number
180887-04XX or 180888-04XX). If it is a 2x2 connection (Molex part number 180777-04XX or 180778-
04XX), then it can connect to a driver or another sensor’s “Output”. Gateway, driver, and other sensor
are supplied separately. For more information on the wire harnesses, see data sheet 987651-5943
**Warning** Do not hot plug the device. Make sure the gateway is disconnected and powered
off from the PoE power before connecting a sensor to the CoreSync bus.
16. To daisy chain another sensor or driver, simply connect a 4-pin to 4-pin Transcend wire harness
from the “Output” of the current sensor, and connect the other end to the “Input” of the next
device.
Entire daisy chain lengths from the start of the GW to the last node must be <30m.
987652-1032
Up to 8 nodes can be daisy chained from one gateway as long as the maximum power of the
gateway is not exceeded.
Mounting locations
Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
3 | P a g e
987652-1032
An image like this but with the
Interface Module
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
ABB ACS380 Series User manual
-
Parker Hannifin Aries AR-20AE User manual
-
ABB ACSM1-04 Series User manual
-
WAGO 750-482 User manual
-
KanexPro HDMMX3232-4K User manual
-
-
-
-
-