KUZCO EP48232 User guide

Category
Mounting kits
Type
User guide

KUZCO EP48232 LED Exterior Pendants are perfect for adding a touch of elegance to your outdoor space. They come with pre-wired LED modules, eliminating the need for bulbs, and are dimmable using an ELV (Electronic Low Voltage) type of dimmer. Installation requires a qualified licensed electrician and should be done on a covered ceiling. Enjoy the warm, inviting ambiance of these stylish pendants, designed to withstand moisture and provide long-lasting illumination.

KUZCO EP48232 LED Exterior Pendants are perfect for adding a touch of elegance to your outdoor space. They come with pre-wired LED modules, eliminating the need for bulbs, and are dimmable using an ELV (Electronic Low Voltage) type of dimmer. Installation requires a qualified licensed electrician and should be done on a covered ceiling. Enjoy the warm, inviting ambiance of these stylish pendants, designed to withstand moisture and provide long-lasting illumination.

2a.
You have now completed the installation of your fixture,
enjoy.
You are now ready to mount the canopy (2a) to the
mounting plate (1c). First connect all wires correctly G
ground to ground, N neutral wire (white to white), L live
wire (black to black) with provided marettes (1b) from the
hardware package. Align the holes in the canopy (2a) to
the threaded screws (1d) hanging downward from the
mounting plate (1c). Push the canopy (2a) up towards the
ceiling so the two screws (1d) clears through the hole in
the canopy (2a). You can now screw on the decorative
nuts (2b) onto the threaded studs.
1a.
1b.
2b.
1e.
3a.
1c.
1d.
Remove the fixture from its original packaging. Remove the
mounting plate (1c) from within the canopy (2a) by remov-
ing the decorative nuts (2b). Secure the mounting plate
(1c) to the junction box (1a) with the screws (1e) provided
in the hardware package.
INSTALLATION SHEET
EP48232
LED Exterior Pendants
START FROM HERE
1.
3.
Please Note:
All Kuzco LED fixtures come with pre-wired LED module(s).
• Unless instructed to do so, please do not touch any part of the LED module(s) as any
unnecessary contact with the module could cause permanent damage.
• For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
• Must be installed on a covered ceiling.
• 120V input
2c.
Attach the rods (2c) to the pendant (3a) by threading in
clockwise until it is secured. Connect the rods and pendant
to the canopy by threading clockwise. (If the input wires
from the driver are too long, please cut accordingly as
an option). Connect the live (black) and neutal (white)
wires onto the DC Driver (See Illustration 2). Connect all
the glass (3b) to the pendant (3a) by threading in clockwise.
(Do not over tighten.)
2.
Illustration 1
3b.
V+
V-
Make sure power is completely off at the fuse box.
Have your fixture installed by a qualified licensed electrician
Prepare everything in a clear area.
Wear gloves at all times during this installation.
Read instructions carefully before you start assembly.
Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W
20181127
: kuzcolighting.com
To prevent moisture from entering the outlet box and
causing a short, seal around the top perimeter between
the fixture and the surface with weather resistant caulking
(See Illustration 1).
4.
Caulking
5.
+
-
DC
Driver
Illustration 2
+
-
+
-
V+
V-
  • Page 1 1

KUZCO EP48232 User guide

Category
Mounting kits
Type
User guide

KUZCO EP48232 LED Exterior Pendants are perfect for adding a touch of elegance to your outdoor space. They come with pre-wired LED modules, eliminating the need for bulbs, and are dimmable using an ELV (Electronic Low Voltage) type of dimmer. Installation requires a qualified licensed electrician and should be done on a covered ceiling. Enjoy the warm, inviting ambiance of these stylish pendants, designed to withstand moisture and provide long-lasting illumination.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI