2. VSEVEN
  3. V7
V7

VSEVEN V7 Operating instructions

  • Hello! I've reviewed the provided document, which is a user manual detailing how to upgrade the firmware of your V7 IFP interactive flat panel using a USB drive. The document outlines two methods for performing the update: one using the power button, and the other through the Admin Debug Menu. I'm ready to answer any questions you have about these procedures.
  • How do I perform a firmware update using the power button method?
    How do I access the Admin DEBUG MENU?
    How long does the firmware update usually take?
IFP Firmware Upgrades using USB
The V7 IFP has two options for the firmware update with the downloaded file using a USD Disk (note: you can also see if
there are over the air (OTA) updates available in the IFP Settings>System menu):
IFP Power Button firmware update method:
1. Extract the contents and move the folder “upgrade_xxxx” to the root folder of a FAT formatted USB disk
2. Insert the USB Drive to the IFP front right USB port
3. Power off the IFP by holding down the power button for a few seconds
4. Push and hold the power button for at least 5 seconds until the button blinks red.
IFP Admin menu firmware update method:
1. Extract the contents and move the folder “upgrade_xxxx” to the root folder of a FAT formatted USB disk
2. Insert the USB Drive to the IFP front right USB port
3. “Input 1 3 7 9” from the IFP remote to bring up the Admin DEBUG MENU
4. Go to UPGRADE in the Admin Debug Menu, then choose “Upgrade All”
5. It can take as much as 10 minutes to complete the entire installation and reboot.
The firmware update usually takes 5-10 minutes and may reboot multiple times. Please wait to make sure the firmware
update is complete before touching anything on the IFP or problems can occur.
/