Aruba EC-S-P User guide

Brand: Aruba

Model: EC-S-P

Type: User guide

Quick Start Guide

EdgeConnect

Aruba

6280 America Center Drive

San Jose, CA 95002

1.877.210.7325 (toll-free in USA)

+1.408.935.1850

www.silver-peak.com/support

EC-S-P

EC-M-H

8 Plug the power cord back into the system.

You have completed the 8-Port NMC module installation and are ready to

physically install the appliance and register it with Unity Orchestrator.

7 Use a #2 Phillips screwdriver to tighten the two thumbscrews

and install the middle black screw on the module.

6 Carefully align, insert, and fully insert the module into the bay.

Caution: Ensure the NMC slides within the guide rails until fully engaged into

system. Failure to fully engage the module may damage the NMC.

5 Remove the module from the packaging.

Remove the module from the ESD bag and follow proper ESD precautions

when installing the module.

1 Gracefullypowerothesystem

This is always required when you install or replace the 8-Port Network Mez-

zanine Card (NMC) because it is NOT hot-swappable.

At least one power supply (AC PSU or DC PSU) is required to operate the

8-Port NMC. A second power supply can be added to provide redundancy

protection.

3 Use a #2 Phillips screwdriver to loosen the two thumbscrews

and the middle black screw on the blank.

4 Remove the blank.

Save the blank in case the system requires servicing.

2 Remove power by disconnecting the power supply.

Remove power by disconnecting the power supply from the power source.

For AC power supplies, remove the power cord.

For DC power supplies, disconnect the terminals.

DC Power supply and

cable terminal

AC Power supply

and cord plug

8-Port NMC Module

Installation

Before You Begin

Check your packing slip to verify

that you have all the necessary

items.

Prepare to install the module

in a proper ESD (Electrostatic

Discharge) environment.

Make sure you have a #2 Phillips

screwdriver.

Aruba EC-S-P User guide

Aruba EC-S-P User guide

Other documents