Page 1

Holden, Chevrolet & GMC

Caravan/Trailer Camera System

• If this Installation requires opening the factory monitor or radio to insert ribbon cables or sub boards, Advanced

ICE Pty Ltd advises that the installation be carried out by an installer with experience working with electronic circuit

boards. Advanced ICE highly recommends the use of a suitable workbench with Antistatic Mat and Earth Strap to

avoid possible damage from a static charge. Advanced ICE Pty Ltd does not accept any responsibility for damaged

caused either to the components in the vehicle or the product, so please do not proceed with the installation if you

do not accept these terms.

following instructions are designed for installation by a qualied 12v installer, car audio installer or auto electrician.

• Interfaces and Navigation modules must not be installed in a location where they will be exposed to extreme

temperatures including, but not limited to, installation on top of a vehicles radio, transmission tunnel or rewall.

Damaged caused by exposure to heat is not covered under warranty.

• If a navigation product is being installed, the end user will need access to the SD Card so as to perform navigation

software updates. Please ensure the navigation module is installed in an easy to access location.

• If the Navigation SD card is not easily accessible by the end user, you the seller, will be responsible for any labour to

assist the customer to access the SD card to perform navigation updates.

Important Product Information

Overview

is engaged.

This manual is a guide to installing the Caravan/Trailer Camera System.

Page 2

Chevy/GMC Harness

Not Used

Dip Switches

Power / CAN

Not Used

Page 3

• In some compatible 2017+ vehicles, the system is equipped with an additional module called the “HMI Bypass

Module” which routes LVDS and camera images to the screen from the HMI. If equipped, the module is normally

located directly beneath the BCM (driver’s side under dash).

• A quick easy way to test for the presence of the HMI Bypass Module:

h Access the OEM HMI unit (Please see Figure 7 in the FAQ section at the end of this document).

h Connect the provided NTV-HAR283 Harness in between the 12-pin plug at the HMI and the vehicle’s

12-pin connector, connect RCAs together.

h Start vehicle.

h Place Vehicle into reverse gear.

h With OEM reverse image on the screen, disconnect the RCAs in the NTV-HAR283 Harness.

1. Begin the process by removing the factory screen, the 1319

multimedia interface is installed there.

2. Remove the Power/Can Plug and insert the plug and play

T-Harness.

3. Remove the LVDS Video cable and insert to the LVDS In mini

USB port on the multimedia interface using the LVDS Input

Cable.

4. Connect the provided LVDS Out cable to the LVDS out Mini

USB Port on the multimedia interface and connect to the LVDS

Please Note: This connector (Figure 3) can be used to power additional cameras.

Page 4

LONG PRESS: to activate

Navigation and Video Source

Display

SHORT PRESS: to return to

OEM Display

FIGURE 5

1. Refer to the rst page of the NAV TV Instructions and use the Cadillac Harness for plug and play power and

2. With the Caravan/Trailer camera (or test camera) connected, ensure that when you put the vehicle in reverse

if automatically displays the secondary camera rather than the factory reverse camera.

Final Tests and Checks

Page 5

Page 6

Page 7