Eye Lighting Turbo User manual

Brand: Eye Lighting

Model: Turbo

Type: User manual

Eye Lighting Turbo is a high-performance LED lighting solution designed for various indoor and outdoor applications. With its IP66 rating, it withstands harsh weather conditions, making it ideal for industrial, commercial, and public spaces. The Turbo offers flexible dimming options, including 3-in-1 dimming and DALI dimming, allowing for precise light control and energy efficiency. Its robust construction and advanced thermal management system ensure long-lasting performance and reliability.

For the latest product information visit the EYE Lighting Australia website

EYE Lighting Australia Pty Ltd

15 Industrial Avenue

Wacol QLD 4076

Email: [email protected]

www.eyelighting.com.au

Tel: +61 (0) 7 3335 3555

Fax: +61 (0) 7 3335 3533

TURBO SINGLE-PHASE 22.07.22

Standard

Electrical Wiring of the Remote Driver Box

TURBO Remote Driver Box

Installation Instructions

CLASSIIP66

Remote driver box weight: 7.5 Kg Max.

Standard Single-Phase AC Input Wiring Conguration:

LED

Open remote driver box: 6× M6 screws (5 Nm torque).

AC Input: ex round cable 5 × 1.5 mm2 or 5 × 2.5 mm2

(Ø9-12mm).

Connect L , , N terminals 220-240Vac 50/60 Hz (for Single-Phase

240V AC Input & Standard LED Driver)

DC Input: ex round cable 3× 1.5 mm2 or 3× 2.5 mm2 (Ø9-12mm).

Connect V+, ,V- terminals.

Note: This Vdc output is not xed (90/103/105/112/135) for dierent

wattage variants.

Tighten the cable glands and tighten the cover of the remote driver box:

6 × M6 screws (5 Nm).

IP 66 Remote Gearbox

3Nm

WAGO

SPD

LED Driver

SPD

L1 L3

Standard

Standard DC Output Wiring Conguration:

L = Live = Brown

= GND = Green / Yellow

N = Neutral = Blue

V- = Negative DC Output = Black

= GND = Green / Yellow

V+ = Positive DC Output = Red

Single-Phase AC Input: Ø9 - 12mm 1.5 ~ 2.5mm2

Power Cable

DC Output: Ø9 - 12mm 1.5mm2

3-Core Power Cable

Dimming Wire / OTP Control

Cable Inlet

Single-Phase 240V AC Input Connection (refer to exact label for correct termination)

Scan for

PDF Version

From

Power

Source

To the

Junction

Box at

rear of

Turbo

LED

Fixture

IP 66 Remote Gearbox

3Nm

WAGO

SPD

LED Driver

SPD

L N

LED DRIVER

3 in 1

Dimming

or DALI

Dimming

Connections

+5 Nm

Important-Safety

This luminaire and remote driver box must be installed by a licensed electrician, following these installation instructions. Before carrying out any installation

or maintenance on this luminaire, ensure that the mains supply is fully isolated. High voltages greater than mains voltage can be present during operation.

Any inadequate installation might cause falling, electric shock, re, or other hazards. Ensure only qualied personnel inspect and maintains the luminaire.

Excessive build-up of foreign material from outer surfaces should be cleaned to maintain the performance of the luminaire. Do not modify the luminaire,

disassemble or replace any component without conrming with supplier rst. Do not touch the power supply when the luminaire is operating.