Hertz Marine HMC U1 User guide

Type
User guide

Hertz Marine HMC U1 is a remote control for Hertz HMR series audio systems. It allows you to control volume, change tracks, select sources, and mute the audio. The backlit buttons ensure easy operation even in low-light conditions. It connects to the HMR series head unit via a wired connection and requires a negative ground 12 V power supply. Installation is simple and straightforward, but it's recommended to consult a professional for assistance if needed.

Hertz Marine HMC U1 is a remote control for Hertz HMR series audio systems. It allows you to control volume, change tracks, select sources, and mute the audio. The backlit buttons ensure easy operation even in low-light conditions. It connects to the HMR series head unit via a wired connection and requires a negative ground 12 V power supply. Installation is simple and straightforward, but it's recommended to consult a professional for assistance if needed.

MUTE
SRC
HMC U1
FOR HMR SERIES
REMOTE CONTROL
QUICK
START
GUIDE
hertzaudiovideo.com
CONTROLS
/ Button
- AM/FM/WB/DAB mode: previous/next preset (short press).
- AM/FM mode: SEEK the next/previous strongest station (long press).
- USB/BT mode: previous/next track (short press).
- USB/BT mode: fast forward / rewind (press and hold).
3
Button
- USB/BT mode: PLAY or PAUSE playback (short press).
4
Button
- Mute ON / OFF (short press)
- Power On (short press)
- Power OFF (long press)
1
VOL +/- Button
- Adjust volume level
2
MUTE
SRC
5
3 3
1
2
4
SRC Button
- Short press “SRC” to move to the next option.
5
INSTALLATION
BEFORE STARTING
1. This device is exclusively for use in vessels with a negative ground 12 V power supply.
2. Read these instructions carefully.
3. Make sure the battery “-” terminal is disconnected before starting.
This is to prevent short circuits during installation. (Figure 1)
INSTALLATION CAUTIONS
1. In order to avoid any interference, do not install the tuner module or control unit in the proximity of
the engine compartment.
2. The use of unauthorized parts can cause permanent damage to the unit.
3. Always check your wire connections to ensure proper installation before turning the unit on.
4. Consult with your nearest dealer for proper installation or if other accessories are needed to
complete the installation.
5. Seek assistance if modifications or drilling holes to your vessel is needed.
6. Do not install the unit where it will be subjected to excessive moisture, dust, dirt, foreign particles or
vibration. Areas of high temperature from the engine, direct sunlight, or heat sources should also be
avoided.
7. Do not install the unit in a location where it will interfere with the vessel operation, or it will injure
the passengers if there is a sudden or emergency stop.
Battery
Figure 1
MOUNTING
MUTE
SRC
MUTE
SRC
MUTE
SRC
CONNECTION
Connect to:
HMR series
+ 12V for
BUTTONS BACKLIGHT
(WHITE COLOR)
Remote Control
Input
25 cm / 9.8 in.
PART OF ELETTROMEDIA
Strada Regina Km 3,500 - Marignano
62018 Potenza Picena (MC) Italy
T +39 0733 870 870 - F +39 0733 870 880
www.elettromedia.it
All specifications subject to change without notice FML004B REV.21C
DIMENSIONS
A A1B C D E
HMC U1 68 70 58 29 18 46 mm
2.68 2.76 2.28 1.13 0.70 1.83 in.
SIZE & MOUNTING
Mounting Hole diameter mm (in.) Ø 45 (1,77)
Mounting Method U-Bracket
MUTE
SRC
A1
A
C
E
B
D
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Hertz Marine HMC U1 User guide

Type
User guide

Hertz Marine HMC U1 is a remote control for Hertz HMR series audio systems. It allows you to control volume, change tracks, select sources, and mute the audio. The backlit buttons ensure easy operation even in low-light conditions. It connects to the HMR series head unit via a wired connection and requires a negative ground 12 V power supply. Installation is simple and straightforward, but it's recommended to consult a professional for assistance if needed.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI