Cell Phone Booster

AT&T Cell Phone Booster Installation guide

  • Hello, I'm your chat assistant. I've reviewed the user manual for the Cell Phone Booster. This document provides essential installation tips, focusing on crucial aspects like frequency matching, antenna placement, and distance requirements. I am ready to answer your questions about the device and these instructions.
  • What should I do before installing the cell phone booster?
    Where should the outdoor antenna be installed?
    Where should the indoor panel antenna be mounted?
    What is the required separation between the outdoor and indoor antennas?
    What should I avoid while installing the device?
Installation Tips
1. Before installation:
Please make sure that the frequency band of your phone matches with that of the
cell phone booster. For details of the testing methods, please refer to the User
Shopping Guide
If the testing result does not match, the booster can't work for you, but we can
replace a correct booster for you, please don't worry and contact us. If you are not
sure, you can also contact us.
2. Tips for installation:
(1) Find a place with the strongest signal on your roof to install outdoor directional
antenna as high as possible, keep it aimed at the near tower of your carrier.
(For iPhone ios system, you can download "Cell Towers US" app; For Android, you
can download "lte discovery" or "open signal" app to check the location of the
signal tower.)
(2) The indoor panel antenna should be mounted on the center of a wall,
about 5-6ft high.
(3) The outdoor and indoor antennas should be separated by a wall and kept at
least 25ft distance, facing away from each other.
Note: Do NOT Power On the Booster if Both Antennas are Not Connected !!!
3. Here are the correct installation examples:
/