Bike Tree HD-101 Operating instructions

Brand
Bike Tree
Model
HD-101
Type
Operating instructions

This manual is also suitable for

ASSEMBLY INSTRUCTIONS
PACKAGE INCLUDES:
ITEM 1: FORK (1) ITEM 5: WALL TUBE (1)
ITEM 2: LEGS (2) -2a & 2b ITEM 6: QUICK-RELEASE PINS (2)
ITEM 3: LOWER TUBE (1) ITEM 7: HANGER RODS (2)
ITEM 4: HUBS (2)
NOTE: HUBS AND LEGS ARE PACKAGED TOGETHER FOR SPACE SAVINGS.
REMOVE ALL PACKAGING AND SLIDE HUBS FROM LEG PARTS BEFORE ASSEMBLY
FIGURE A: HUB ASSEMBLY
ITEM 7
ITEM 4
HUB
ASSEMBLY
HUB
ASSEMBLY
1. HUB ASSEMBLY:
Insert hanger rod (ITEM 7) into desired position within the hub
and slide rear hub cover to close. See Figure A for details.
REPEAT for second hub assembly.
FOR MORE INFORMATION, PLEASE CONTACT US::
1701 W. 10th St. Suite 18 Tempe, Arizona 85281 USA
480-968-2656 www.bike-tree.com
2. Insert legs (ITEM 2 --2a & 2b) into fork (ITEM 1).
3. Insert lower tube (ITEM 3) into ITEM 1.
4. Slide first HUB ASSEMBLY over ITEM 3 and
secure using quick-release pin (ITEM 6).
5. Slide second HUB ASSEMBLY over wall tube
(ITEM 5) and secure using quick-release pin
(ITEM 6).
6. Insert ITEM 5 into ITEM 3.
7. Lean assembled Bike Tree against wall.
Vertical tubes must be parallel to the wall.
Rubber feet of both legs must be equally spaced
from wall.
8. Adjust height of lower HUB ASSEMBLY so lower
bicycle tires are off the ground.
9. Adjust height of upper HUB ASSEMBLY so
upper bicycle clears the loweer bicycle.
10. Always center bicycles on the
hanger rods (ITEM 7)
  • Page 1 1
  • Page 2 2

Bike Tree HD-101 Operating instructions

Brand
Bike Tree
Model
HD-101
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents