REMOVE ALL PACKAGING BEFORE ASSEMBLY
FOR MORE INFORMATION, PLEASE CONTACT US::
1701 W. 10th St. Suite 18 Tempe, Arizona 85281 USA
480-968-2656 www.bike-tree.com
2. Insert legs (ITEM 2 --2a & 2b) into fork (ITEM 1).
3. Insert lower tube (ITEM 3) into ITEM 1.
4. Slide first HUB ASSEMBLY over ITEM 3 and
secure using quick-release pin (ITEM 6).
5. Slide second HUB ASSEMBLY over wall tube
(ITEM 5) and secure using quick-release pin
(ITEM 6).
6. Insert ITEM 5 into ITEM 3.
7. Lean assembled Bike Tree against wall.
Vertical tubes must be parallel to the wall.
Rubber feet of both legs must be equally spaced
from wall.
8. Adjust height of lower HUB ASSEMBLY so lower
bicycle tires are off the ground.
9. Adjust height of upper HUB ASSEMBLY so
upper bicycle clears the loweer bicycle.
10. Always center bicycles on the
hanger rods (ITEM 7)
2. insert legs (ITEM 2) into fork (ITEM 1).
REPEAT for the other side.
3. Insert lower tube (ITEM 3) into fork (ITEM 1).
REPEAT for the other side.
4. Slide HUB ASSEMBLIES into lower tube and
"U"-Tube (ITEM 5) and secure using quick-release
pins.
REPEAT for the other side.
1. HUB ASSEMBLY:
Insert hanger rod (ITEM 7) into desired position
within the hub and slide rear hub cover to close.
See Figure A for details.
REPEAT for the rest of the hub assemblies.
5. insert "U" tube assembly to the
lower assemblies (see step 3).
6. Make sure floor is clean and dry
before loading bicycles.
7. Adjust height of the lower HUB
ASSEMBLIES so lower bicycles
are off the ground.
8. Adjust height of the upper HUB
ASSEMBLIES so upper bicycles
clear the lower bicycles
9. Always center bicycles on the
hanger rod (ITEM 7)