Danfoss FFKM and FKM replacement O-ring kits for REG-SA_SB - DN 10 to 40 and SCA-X_CHV-X all sizes - DN 15 to 125 Installation guide

Model: FFKM and FKM replacement O-ring kits for REG-SA_SB - DN 10 to 40 and SCA-X_CHV-X all sizes - DN 15 to 125

Installation Guide

FFKM and FKM replacement O-ring kits for REG-SA/SB, DN 10 to 40

and SCA-X / CHV-X all sizes (DN 15 to 125)

148R9633

• Do not remove the bonnet while the valve is still under pressure.

• Remove the standard CR O-ring from the valve with a “soft” tool

preventing scratching of the valve O-ring groove (ﬁg. 1).

• Add a small drop of oil, (same type as the compressor oil), then mount the new

FFKM or FKM O-ring + tag (ﬁg. 2) for the correct FFKM or FKM O-ring type.

• For replacing standard CR O-rings, use inspection kits.

• FFKM and FKM O-rings kit only contain FFKM or FKM O-rings.

FFKM O-ring (WHITE tag):

Applicable for R717 (NH₃) heat pump applications in the temperature range of +100°C and +150°C.

FKM O-ring (BLUE tag):

Applicable for R1270 (Propylene) applications in the temperature range of -60°C and +150°C.

FFKM (R717 HP)

WHITE tag

FKM (R1270)

BLUE tag

Blue tag

REG example:

1 2

Model: FFKM and FKM replacement O-ring kits for REG-SA_SB - DN 10 to 40 and SCA-X_CHV-X all sizes - DN 15 to 125

Download PDF