Kichler Lighting 52094AUB User manual

Type
User manual
IS-52094-US
Were here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
1) Find the appropriate threaded holes on mounng
strap[B]. Assemble mounng screws[G] into threaded
holes.
2) Aach mounng strap to outlet box[A] using the strap
mounng screws[D]. Mounng strap can be adjusted to
suit posion of xture.
3) Grounding instrucons: (See Illus. a or b).
a) On xtures where mounng strap is provided with a
hole and two raised dimples, wrap ground wire from
outlet box around green ground screw, and thread
into hole.
b) On xtures where a cupped washer is
provided,aach ground wire from outlet box under
cupped washer and green ground screw, then thread
into mounng strap.
If xture is provided with ground wire, connect xture
ground wire to outlet box ground wire with wire
connector aer following the above steps. Never connect
ground wire to black or white power supply wires.
4) Make wire connecons. Reference chart below for
correct connecons and wire accordingly.
Connect Black or Red
Supply Wire to:
Connect White Supply
Wire to:
Black White
*Parallel cord (round &
smooth)
*Parallel cord (square &
ridged)
Clear, Brown, Gold or
Black without Tracer
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other
than green) with copper
conductor
Insulated wire (other
than green) with silver
conductor
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth
(see illus.)
Neutral Wire
5) Push xture to ceiling, carefully passing mounng screws
through holes in canopy[C].
NOTE: Be certain wires do not get pinched between
mounng strap and canopy, or canopy and ceiling.
6) Use knobs[F] and lockwashers[E] to secure xture.
Tighten to secure.
7) Insert recommended bulbs. (Not supplied).
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
a
b
Fixture Diagram
Parts List
Cauons
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starng and during the installaon.
WARNING:
This xture is intended for installaon in accordance
with the Naonal Electrical Code (NEC) and all local code
specicaons. If you are not familiar with code requirements,
installaon by a cered electrician is recommended.
CLEANING:
• Always be certain that electric current is turned o
before cleaning.
• Only a so damp cloth should be used. Harsh cleaning
products may damage the nish.
[A] Outlet Box
[B] Mounting
Strap
[C] Canopy
[D] Strap
Mounting
Screws
[E] Lockwashers
[F] Knobs
[G] Mounting
Screws
Installaon Instrucons
A
B
D
G
F
E
C
  • Page 1 1
  • Page 2 2
  • Page 3 3

Kichler Lighting 52094AUB User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI