2. Jet Performance
  3. 91201

Jet Performance 91201 Installation guide

  • Hello! I have reviewed the installation instructions for the JET Performance Products PCMCDJ Power Control Module designed for Jeep Wranglers. The document outlines the installation process, emphasizing the need to disconnect the battery and allowing time for the vehicle's systems to reboot. I'm ready to answer any questions you may have about the installation process or the module itself.
  • What happens if I disconnect the battery?
    Where do I install the module?
    What should I check after installation?
JEEP WRANGLER
POWER CONTROL
P/N PCMCDJ
© 2022
MODULE Installation
Instructions
IMPORTANT NOTE FOR ALL VEHICLES EQUIPPED WITH
ENTERTAINMENT SYSTEMS, BACK UP CAMERAS, NAVIGATION
SYSTEM, ETC..
Disconnecting the battery requires the system to go through a Reboot process,
this process may take up to 1 hour before the systems are working properly
again. Don't panic, be patient, they will return to normal. Note that that will
happen anytime you disconnect or have a battery go dead.
Jeep
Wrangler
1. Locate and remove the vehicles computer.
2. Place the computer(ECU) on a workbench or table.
3.Install the JET module on the BROWN (top) connector by pulling
out the locking handle to line it up with the guides on the PCM and
then push down rmly to make sure it is seated all the way into the
PCM.
4. Push the locking handle in to lock the module down.
5. Re-install the computer and reconnect both wiring harnesses.
6. Start the vehicle and verify that the Check Engine Light is NOT
on.
6
Jeep Wrangler Jeep Grand Cherokee
STEP 3 STEP 4
**NOTE: Always disconnect negative battery terminal before attemping to install any electrical component
JET Performance Products, Inc.
17491 Apex Circle
Huntington Beach, California 92647
714-848-5515 | www.jetchip.com | 714-847-6290 fax
/