Orieme BRIO 30 G User manual

Brand: Orieme

Model: BRIO 30 G

Category: Household fans

Type: User manual

This manual is also suitable for

MANUALE D'ISTRUZIONI - INSTRUCTION MANUAL

BEDIENUNGSANLEITUNG - LIVRET D'INSTRUCTIONS

MANUAL DE INSTRUCCIONES

OI 11

RoHS

VENTILATORE DA TAVOLO

DESK FAN

TISCHVENTILATOR

VENTILATEUR DE TABLE

VENTILADOR DE MESA

BRIO 23 – BRIO 30 – BRIO 40

Ø 23 cm Ø 30 cm Ø 40 cm

Page is loading ...

(1) Fan base

(2) Pillar

(3) Fan speed switch

0=Off

1=Low speed

2=Middle speed

3=High speed

(4) Motor head

(5) Set Tilt: take the fan off,

and then set the tilt

(6) Clutch knob: pull or push

the knob to set

oscillation/un-oscillation

Oscillation

Un-oscillation

APPLIANCE COMPONENTS

Fitting the media (Fig. B)

-Screw out base screw (7),

-Put the pillar into the base,

and then screw the base

screw (7) tightly.

ASSEMBLING

ENGLISH

GENERAL DIRECTIONS

1.Remove the packaging and make sure that the appliance is intact. If in doubt, do not use it and

contact qualified personnel only. Packaging materials (plastic bags, polystyrene, staples etc.) must be

kept out of the reach of children as they could be hazardous.

Caution:

- This appliance is not intended for use by persons (including children) with reduced physical, sensory

or mental capabilities, or lack of experience and knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a person responsible for their safety.

- Children should be supervised to ensure that they do not play with the appliance.

2.Before connecting the appliance, check that the appliance rating corresponds to the mains rating. If

the power cord is damaged, it must be replaced by the manufacturer or its service agent or a similar

qualified person in order to avoid a hazard.

3.This appliance must only be used for the purpose for which it has been manufactured, i.e. as a

desk fan. The manufacturer is not responsible for any damage caused by improper or incorrect use.

4.Before cleaning or carrying out maintenance on the appliance, disconnect it from the electrical mains

by pulling out the main plug.

5.If the appliance is faulty and/or operating incorrectly, switch it off without tampering with it. If any

repair is required, please contact our after-sale centres only and ask for original spare parts. If the

above is disregarded, the safety of the appliance may be compromised.

6.Switch off the appliance when not in use.

7.The use of any electrical appliance calls for the awareness of some basic rules, such as:

a. do not touch the device with wet or damp hands or feet

b. do not leave the appliance exposed to atmospheric agents

8.Do not use the appliance in the presence of potentially flammable or explosive liquids or gases.

9. The appliance conforms with Directives 2004/108/EC regarding Electromagnetic Compatibility (EMC)

and Directives 2006/95/EC regarding Low Voltage (LV).

10. This product is intended for household use ONLY and not for commercial / industrial or outdoor use.

MAINTENANCE

Before carrying out routine cleaning, switch off the fan and disconnect mains power. Use a soft, damp

cloth only and do not use abrasive substances.

NB. Do not submerge any part of the fan in the water.

TECHNICAL DATA

Power consumption:

Dimensions:

Weight:

CAUTION

35 W (Brio 23) - 45 W (Brio 30) - 55 W (Brio 40)

250x240x380 mm (Brio 23) – 350x350x500 mm (Brio 30) – 480x450x600 mm (Brio 40)

1.1 kg (Brio 23) – 1.5 kg (Brio 30) – 1.95 kg (Brio 40)

The symbol on the product means that at the end of its life, the appliance must not be considered

normal waste but hazardous waste and, as such, must be disposed of in specific recovery and disposal

areas, as prescribed by the EC Directive 2002/96/EC (WEEE). By disposing of this product correctly,

you can prevent negative consequences for the environment and for human health, due to the

presence of potentially hazardous substances in the product.

OPERATING

Place the appliance on a dry and flat surface. Operate the appliance with the noted power voltage

which was marked on the appliance (A.C. only). Do not immerse the appliance into water; use a damp

cloth to wipe the body and a dry one to wipe over the water. Note: please let the appliance cool down

fully before cleaning.

1.Plug the power cord set into a standard

domestic power outlet.

2.To make/stop the fan head oscillate, pushes

down/pull the clutch knob.

3.To adjust the airflow upward or mild downward,

simply adjust the motor head to desired angle by

hand freely.

4.Speed is controlled by Speed switch.

MANIGLIA

INTERRUTTORE

PERNO ATTIVAZ IONE

SPEED SWITCH

CLUTCH KNOB

HANDLE

Mounting the cooling fan (Fig. C)

1.Unscrew the spinner (13) clockwise and the nut (9) counter-clockwise then remove

both of them

2.Screw out the screw(15) and then fix Rear Guard (8) in proper position by tightening

the screw(15) with the screwdriver .(See Fig.C1)

3.Screw on plastic nut (9) tightly to attach rear guard (8)

4.Install Fan Blades (11) into Blade Holder (10) in the proper position

5.Cover Blade Holder Cover (12) and then fix onto motor shaft (7) (See Fig.C2)

6.Use Spinner (13) to attach blade set onto motor shaft (7) counter-clockwise

7.Fix Rear Guard (8) into the Front Guard (14) in the proper position

Page is loading ...

Orieme BRIO 30 G User manual

Brand: Orieme

Model: BRIO 30 G

Category: Household fans

Type: User manual

This manual is also suitable for

Download PDF

report

in other languages

italiano: Orieme BRIO 30 G Manuale utente
français: Orieme BRIO 30 G Manuel utilisateur
español: Orieme BRIO 30 G Manual de usuario
Deutsch: Orieme BRIO 30 G Benutzerhandbuch

Orieme BRIO 30 G User manual

This manual is also suitable for

Orieme BRIO 30 G User manual

in other languages

Related papers

Other documents