Orieme VIVALDI User manual

VENTILATORE A TORRE

TOWER FAN

TURMVENTILATOR

VENTILATEUR À COLONNE

VENTILADOR DE TORRE

RoHS

MANUALE D'ISTRUZIONI - INSTRUCTION MANUAL

BEDIENUNGSANLEITUNG - LIVRET D'INSTRUCTIONS

MANUAL DE INSTRUCCIONES

OI 11

VIVALDI

Page is loading ...

MODE

1

2

3

4

5

6

7

8

9

10

11

12

13

a

b

c

a. FRONT

1. LCD

2. SPEAKER

3. PERFUME COVER

4. FAN EXHAUSTED GRILL

5. FRONT COVER

6. HEATER EXHAUSTED GRILL

7. BASE GLASS

b. SIDE

8. SD or USB or AUX IN PORT

c. REAR

9. REMOTE CONTROLLER

10. HANDLE

11. REAR HOUSING

12. POWER SWITCH

-FAN/HEATER SELECT

13. PLUG

On/Off

Mode Timer setting

Oscillation

Temp/

Clock/

Volume

Decrease

Temp/

Clock/

Volume

Increase

Music On/Off

a = loose

b = tight

a

b

2

3

Remove the product carefully from the plastic bag and the carton. Follow step 1 to 3 to fix base.

Put the heater on a stable flat surface. Set the main power foot switch to’ OFF’. Plug the

cord set into a 220-240V~A.C. electrical outlet.

1

ASSEMBLING

4

=ON

=OFF

9

GENERAL DIRECTIONS

1. Remove the packaging and make sure that the appliance is intact. If in doubt, do not use it

and contact our Technical Assistance Centre. Packaging materials (plastic bags, polystyrene,

staples etc.) must be kept out of the reach of children as they could be hazardous.

Caution:

This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance by a person responsible for

their safety.

Children should be supervised to ensure that they do not play with the appliance.

2. Before connecting the appliance, check that the appliance rating corresponds to the mains

rating.

If the power cord is damaged, it must be replaced by the manufacturer or his service agent or a

similar qualified person in order to avoid a hazard.

3. This appliance must only be used for the purpose for which it has been manufactured, i.e. as

a tower fan. The manufacturer is not responsible for any damage caused by improper or

incorrect use.

4. Before cleaning or carrying out maintenance on the appliance, disconnect it from the

electrical mains by removing the plug from the electrical outlet or by switching off the system

switch.

5. If the appliance is faulty and/or operating incorrectly, switch it off without tampering with it. If

the above is disregarded, the safety of the appliance may be compromised.

6. Switch off the appliance and remove the plug from the electrical outlet when not in use.

7. The use of any electrical appliance calls for the awareness of some basic rules, such as:

- do not use the appliance near sources of water such as baths, showers or swimming pools

- do not touch the appliance with wet or damp hands or feet

- do not leave the appliance exposed to atmospheric agents

- the heater must not be located immediately below a socket- outlet

- in order to avoid overheating, do not cover the heater

8.The unit has an acoustic warning device that is triggered in the event of overheating during

the "heating" function. If it goes off, turn off the appliance immediately. IMPORTANT:

when the alarm sounds, do NOT use the appliance.

9. Max. ambient temperature 35°C.

10. Do not use the appliance in the presence of potentially flammable or explosive liquids or

gases.

11. In order to avoid overheating, do not cover the heater.

ENGLISH

=HEATER

=FAN

09

10

CURRENT TIME SETTING

1h

6h

12h

18h

24h

Press the “ ” timer button

for 3 seconds, the hour digit

start to flash

1 2

Press “+” or “-” button set the

current hour

3

Press the “ ” timer button

to confirm the hour selected,

and the minute digit start

to flash

4

Press “+” or “-” button set the

current minute, press “ ”

timer to confirm selected

1h

6h

12h

18h

24h

1h

6h

12h

18h

24h 1h

6h

12h

18h

24h

TIMER SETTING

1h

6h

12h

18h

24h

empty dot: off ( canceled) status

selected dot: working ( confirmed) status

flash dot: selected ( waiting confirmation) if without any

timer operations, flashing carry out 10 seconds

1h

6h

12h

18h

24h

Segments hours are 24:

corresponding to 24 hours

of the day

5s

1

Low speed

High speed

Nature wind

Sleeping wind

Mid speed

Cool fan

Low heat

Hight heat

Auto

2 3

Press the “ I ” button

turn on power and

turn the other switch

to the “ ”

Press the “MODE” button

can set speed option:

low medium maximum

natural wind sleeping wind

5s

1

2 3

Press the “ I ” button

turn on power and

turn the other switch

to the “ ”

Press the “ ” power button

the temperature and the

current time display for 5

seconds alternately, “ ”

high heat will be activated.

Press the “ Mode” button

can set heater option:

Auto cool fan low heat

high heat

When chose “AUTO”mode, the temperature will flash and a target temperature can be

set by pressing “+”or “-”button, the target temperature can be from 10

℃ to 35℃. When

the environment temperature lower than the target temperature, the heater start to work.

HEATER MODE

FAN MODE

flash for 5 seconds

and confirm selected

Press the “ ” power button,

the temperature and the

current time display for 5

seconds alternately,“ ” low

speed will be activated.

11

12

1h

6h

12h

18h

24h

Pressing the “ ” timer button, one dot will flash

1h

6h

12h

18h

24h

2

1h

6h

12h

18h

24h

3

1

1h

6h

12h

18h

24h

Press “+” or “-” button can move dot for time selection

Press “ ” timer button to confirm the selected time, dot

become “ ” then the next dot will become flashing, after

10 seconds the dot flashing stops and the timer setting

is completed

If you want to cancel the timer setting ,press “ ” button, and

use “+” or “-” button to move flash dot, when the “ ” become “ ”,

press the “ ” button to cancel the selected time and dot will be “ ”

If you want to set the continuous working time, repeat pressing “ ”

button, the “ ” will become “ ” one by one, then next dot will

flash for 10 seconds

13

14

OSCILLATING

1h

6h

12h

18h

24h

Press the “ ” oscillation button will allow the Heater to oscillate. To stop the oscillation,

press the “ ” oscillation button once more.

1h

6h

12h

18h

24h

open

close

PERFUME FUNCTION

There is a perfume slot on the right of speaker. Drop some perfume to the ceramic and

insert to the slot and close the cover.

(Important: Must use water-based fragrance, can not use oil-based fragrance)

1

Use a coin to open the

cover as picture 1 show

Take out the ceramic

and drop the water-based

fragrance

Use a coin and close the

cover as picture 3 show

3

2

21

REMOTE CONTROL

1. lnstall two “AAA” batteries.

2. The Remote Control button is labeled as below.

SAFETY FEATURES

1. A thermal overload protector is built in to prevent overheating.

2. When an overheat temperature is reached, the Heater will be automatically shut off. Once

unit cool down, can be re-booted by user.

3. If the unit is tilted, a safety system automatically will cut off the power, after resume it to

vertical position , it does not operate, it only can operate again by pressing on/off switch on the

top of body

MAINTENANCE

WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT

IMMERSE APPLIANCE IN WATER!

CLEANING: IMPORTANT! DO NOT IMMERSE APPLIANCE IN WATER!

Clean the Air Inlet with the vacuum brush attachment on your Vacuum cleaner,

Clean the body of the Appliance with a soft Cloth.

CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the

Appliance. NEVER use ALCOHOL OR SOLVENTS.

STORAGE: Store the Appliance with these instructions in the original in a cool, dry place.

ATTENTION

The symbol on the product means that at the end of its life, the appliance must not be

considered normal waste but hazardous waste and, as such, must be disposed of in specific

recovery and disposal areas, as prescribed by the EC Directive 2002/96/EC (WEEE). By

disposing of this product correctly, you can prevent negative consequences for the environment

and for human health, due to the presence of potentially hazardous substances in the product.

For more detailed information about recycling this product, contact the local authorities, the local

waste disposal service or the shop from which the product was purchased. Unlawful disposal

will be punished according to the law.

1

2

SD

AUX In

USB

Music Play

Mp3 bracket assembly

Music Play operation

1h

6h

12h

18h

24h

Compression format: MP1/MP2/MP3

MP3 bit rates: 8-320 kbps and VBR (= Variable BitRate)

MP3 sample rates: 16, 32, 44.1, 48, 11.025, 22.050, 24, 8 kHz

Supported Number of Files/Folders: File: Max. 1000 Folder: Max. 1000 (including File)

Do not use “ ” button to close music directly, If you do that, the music will

continue automatically after few minutes, reminding you that the music is

not closed yet. To stop the music please touch the “ ” button.

1

2

3

1h

6h

12h

18h

24h

1h

6h

12h

18h

24h

Insert a SD card,mp3 player

or a U disk to corresponding

port on right of the unit,and

press the “ ” button , will start

to play music.

15

16

Press the “ ”button to close

music

USB/SD port - Music play

Press the “ + ” or “ - ” button to

increase or decrease the volume.

AUX input - Music play

Use Mp3 player to adjust the volume

USB/SD port - Music play

You can use the button

" " or " " of remote

control to play previous or

next track of music.

AUX input - Music play

Use Mp3 player control to

play previous or next track

of music

Page is loading ...

Orieme VIVALDI User manual

Orieme VIVALDI User manual

in other languages

Related papers

Other documents