MAINTENANCE & CLEANING
Before carrying out routine cleaning, switch off the fan and disconnect mains power. Use a soft,
damp cloth only and do not use abrasive substances.
NB:. Do not submerge any part of the fan in the water.
Attention: To avoid injured, dangerous and damage, please remember to disconnect the plug
before cleaning and remount the rear guards after cleaning and before use.
TECHNICAL DATA
Power supply: 12 V DC
Power: 30 W
Dimensions: 1200 x 300 x 300 mm
Weight: 3.7 kg
CAUTION
The symbol on the product means that at the end of its life, the appliance must not be
considered normal waste but hazardous waste and, as such, must be disposed of in specific
recovery and disposal areas, as prescribed by the EC Directive 2002/96/EC (WEEE). By
disposing of this product correctly, you can prevent negative consequences for the environment
and for human health, due to the presence of potentially hazardous substances in the product.
For more detailed information about recycling this product, contact the local authorities, the local
waste disposal service or the shop from which the product was purchased. Unlawful disposal will
be punished according to the law.
Fan ON/OFF button
Speed selection button: 1 / 2 / 3 / 4 / 5
Oscillation ON/OFF button
Selectable air delivery & Natural Mode button
Timer Setting button: 2 / 4 / 8 hours.
Insert the plug into a power outlet.
ON/OFF button
related LED function indicator light goes on.
to switch on or switch off the fan. When the fan switches on, the
5 levels speed control, press this key to change the speed,
function indicator light goes on, speed level shows in the bottom of the unit
the related LED
Oscillating function, press it will allow the Fan to
stop oscillation
oscillate, press once more to
Selectable air delivery position (top panel related LED function indicator light
goes on.),
st nd st nd
- press once: 1 +2 fans open (1 and 2 Speed indicator goes on);
nd rd nd rd
- press twice: 2 + 3 fans open (2 and 3 Speed indicator goes on);
rd th rd th
- press third: 3 + 4 fans open (3 and 4 Speed indicator goes on);
press fourth to select the Natural Mode. Natural Mode: 4 fans open, speed will
change in each 10 seconds, sequence as: speed level 1,2,3,4,5,4,3,2,1 (move in
circles, related Speed indicator goes on).
st nd
Press this key again returns to 1 + 2 fans open.
Press the TIMER key to set 2 / 4 / 8 hours timer setting,
indicator light goes on: Red: 2 hours; Orange: 4 hours; Green: 8 hours. when the
time is over, the fan will switch off automatically (returns stand by mode).
the related LED function
OPERATION
07
08
If the fan is really dirty, you can detach rear guards
and clean inside of the fan.
1. screws of the rear guards by a sized screw
driver;
2.turn the rear guards counterclockwise and take
it out;
3.use vacuum cleaner to clean the dust or use a
damp cloth to remove the dust on fan, but fan is
not detachable from motor shaft and do not uses
water to clean it;
4. after cleaning, close the rear guards by turn it
clockwise and screwed before use.