the great outdoors by Minka Lavery 8956-94 Installation guide

Type
Installation guide
INSTALLATION INSTRUCTIONS
For Model 8956
READ AND SAVE THESE INSTRUCTIONS
W
A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
HANGING THE FIXTURE (Fig. 1)
1. Shut off the power at the circuit breaker and remove the old fixture.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Take care not to lose any small parts necessary for
installation.
CONNECTING THE WIRES (Fig. 2)
3. While supporting the lantern connect the electrical wires as shown
in Fig. 2.
If your outlet has a ground wire (green or bare copper),
connect the fixture ground wire to it. If not, consult your electrician
for proper grounding. After the wires are connected, tuck them
carefully inside the post.
COMPLETING THE INSTALLATION (Fig.1)
4. Place the fixture (F) onto post (H) (not supplied), and secure with the 3
mounting screws (G).
5. Screw the central pipe (I) to the socket cluster.
6. Install bulbs. (3-60W Type-B. not supplied). DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
(NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
7. Attach the cover (E); decorative ring (D); decorative cover (C)
onto the fixture (F) and secure with washer (J), hex nut (B),
finial (A).
8. Turn on the power at fuse or circuit box.
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.1
Fig. 2
FIXTURE FIXTURE
WIRES WIRES
Black or White or
Smooth Ribbed
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE HOUSE
WIRES WIRES
White Green or
(Neutral) Bare
Copper (Ground)
  • Page 1 1

the great outdoors by Minka Lavery 8956-94 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI