2. Baxton Studio
  3. BBT61137-A2 Natural Wood-Queen Bed

Baxton Studio BBT61137-A2 Natural Wood-Queen Bed Assembly Instructions

  • Hello! I'm a chat assistant and I've reviewed the assembly instructions for the Bed BBT 61137 A2. This document contains detailed steps for putting together your new queen bed, including how to attach the bed legs and side rails, along with the necessary hardware. The document also provides cautions regarding tightening the bolts. I'm here to help answer any questions you might have about the bed assembly.
  • What tool is needed for assembly?
    Should the bolts be fully tightened immediately?
    What should I do when moving the bed?
1 OF 2
PART LIST
ITEM DESCRIPTION QTY
A HEADBOARD 1 PC
B FOOTBOARD 1 PC
C BED LEG 4 PCS
D SIDE RAIL 2 PCS
E CENTER RAIL 1 PC
F CENTER SUPPORT LEG 3 PCS
G BED SLAT 1 SET
HARDWARE LIST
ITEM DESCRIPTION QTY
1 JCBB BOLT M8 x 20mm 16 PCS
2 M8 FLAT WASHER 16 PCS
3 M8 SPRING WASHER 16 PCS
4 WOOD SCREW M4 x 38mm 9 PCS
5 M5 ALLEN KEY (BALL SHAPE) 1 PC
6 VMB 3133 4 PCS
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS : 1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.
Tool needed : Screwdriver (not provider).
ASSEMBLY INSTRUCTIONS
MODEL : BBT 61137 A2 QUEEN BED
STEP 1
STEP 1.1
STEP 2
x 4
6
C
STEP 1.2
A
B
C
C
C
A
B
5
1
3
2C
C
C
ASSEMBLY INSTRUCTIONS
STEP 5
2 OF 2
STEP 3 STEP 4
STEP 6
* When moving the bed position, the center support legs
must be adjust to be straight to avoid any broken problem.
STEP 3.1 STEP 3.2
D
D
23
1
5
A
B
E
F
E
E
4
G
G
/