Burndy 50126061 Installation guide

Hello! I've reviewed the installation instructions for the BURNDY WCH2 and WCH2GS cable hangers. This document outlines the correct methods for installing these hangers on solar module frames, emphasizing orientation based on wire routing. I'm ready to address any questions you have about these products or the installation process.
What is the recommended installation practice for these cable hangers?

How should the hanger be oriented when wires are not perpendicular?

WCH2GS

WCH2

Document Number 50126061 Rev A

Page 1 of 2

Wire Management Solutions

CABLE HANGERS

INSTALLATION INSTRUCTIONS

For SOLAR MODULE FRAMES

BURNDY recommends that the sufficient details of the installation be

submitted to the AHJ for approval before any work is started.



LISTED

Custom designs are available upon request.

For information regarding Wiley cable hangers,

please see the technical documents section of our website.

E473109

DETAIL A

SCALE 1:1.1

DETAIL B

SCALE 1:1.1

Document Number 50126061 Rev A

Page 2 of 2

SYSTEM OVERVIEW

CABLE HANGERS

WCH2 / WCH2GS INSTALLATION ORIENTATION

When installing the WCH2 or WCH2GS Cable Hangers, care should be taken to ensure pressure

from the wires does not cause the cable hanger to open during use.

When wires are not routed directly perpendicular to the orientation of the hanger as shown below,

the hanger should be oriented so pressure from the weight of the wires forces the hanger closed.

Module Frame

Cable Bundle