2. Vehicles & accessories
  3. Motor vehicle accessories & components
  4. Motorcycle Accessories
  5. PAC
  6. AVS21

PAC AVS21 User manual

  • Hello! I am an AI chatbot trained to assist you with the PAC AVS21 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Pacic Accessory Corporation
®
| Ph. 866-931-8021 | [email protected]
©2015 Pacic Accessory Corporation
www.pac-audio.com
Rev. 040815
AVS-21
Two-Way Audio/Video Switcher
Pacific Accessory Corporation
AVS-21
Two-Way Audio/Video Switcher
Pacic Accessory Corporation
®
| Ph. 866-931-8021 | [email protected]
©2015 Pacic Accessory Corporation
www.pac-audio.com
Rev. 040815
Pacific Accessory Corporation
J1850
Class 2
VPW
Class 2
J1850
100011101111001001101100
111010000110110111001100
EOD
CRC
100011101111001001101100
111010000110110111001100
Class 2
Class 2
J1850
The AVS-21 is a two way A/V switcher designed for use with any of the PAC BCI interfaces. The AVS-21
can also be used as a stand alone unit for any application requiring a two way A/V switch.
Introduction & Features
Important Notes
1. The A/V output will pass the A/V 1 input at all times until the module is triggered.
2. The module can be triggered by either a positive or negative trigger, however when used with a BCI module it will always be a positive
trigger.
1. The black and red wires in the 2-pin plug are the trigger wires. If you are using the AVS-21 with a BCI interface you will connect the black wire
to ground and the red wie to the red programmable output wire on the BCI interface. If you are using the AVS-21 in any other application,
you can connect the red and black trigger wires to best suite your needs.
2. Connect the RCAs labeled “A/V1 IN” to the primary A/V source.
3. Connect the RCAs labeled “A/V2 IN” to the secondary A/V source.
4. Connect the RCAs labeled “A/V OUT” to the screen/head unit.
Installation Steps
The AVS-21 is a two way A/V switcher designed for use with any of the PAC BCI interfaces. The AVS-21
can also be used as a stand alone unit for any application requiring a two way A/V switch.
Introduction & Features
Important Notes
1. The A/V output will pass the A/V 1 input at all times until the module is triggered.
2. The module can be triggered by either a positive or negative trigger, however when used with a BCI module it will always be a positive
trigger.
1. The black and red wires in the 2-pin plug are the trigger wires. If you are using the AVS-21 with a BCI interface you will connect the black wire
to ground and the red wie to the red programmable output wire on the BCI interface. If you are using the AVS-21 in any other application,
you can connect the red and black trigger wires to best suite your needs.
2. Connect the RCAs labeled “A/V1 IN” to the primary A/V source.
3. Connect the RCAs labeled “A/V2 IN” to the secondary A/V source.
4. Connect the RCAs labeled “A/V OUT” to the screen/head unit.
Installation Steps
/